Mustang Forums at StangNet

Complete 2V Engine/Tranny Extras

This is a discussion on Complete 2V Engine/Tranny Extras within the SW Classifieds forums, part of the Southwest category; From the CAI back to the X pipe: 2000GT - C&L CAI 80mm ma - Accufab 75mm TB - Comp ...

Go Back   Mustang Forums at StangNet > Regional Forums > Southwest > SW Classifieds

Over 151,000 Members!!

Register Vendors Garage FAQ Calendar Search Today's Posts Mark Forums Read



Reply
 
LinkBack Thread Tools Rate Thread Display Modes
  #1 (permalink)  
Old 03-14-06, 06:27 PM
Member
 
Join Date: January 2006
Posts: 5
Complete 2V Engine/Tranny Extras

From the CAI back to the X pipe: 2000GT
- C&L CAI 80mm ma
- Accufab 75mm TB
- Comp Cams
- Steeda UDP
- BBK long tubes w/ o/r X-pipe

- T-45 with 4,000 (four thousand) miles after Standard Gear and Tranmission in Fort worth TX rebuilt it.
- Steeda Short Throw shifter
- RAM dual friction clutch
- RAM alluminum flywheel

The motor (windsor) is still in the car until i do my swap or someone wants it. preferably assembled, however, i will part it out if someone desides to buy the bulk of it first. Welcome to drive the car and see it run if your'e local. NOTHING but royal purple has been run in this motor, its very strong, good compression, etc. The tuning was done by Mike Wilson at Dallas Mustang and the numbers were 289/298 before the tranny, clutch, flywheel, and UDP's were installed. 100k miles is the downside to this, but like i said, it does have lots of life into it, as the valves were reworked when the cams were installed @80k.

email- brkrukiel@hotmail.com
phone- (817) 673-8783
or just pm. email is best though.
Reply With Quote
  #2 (permalink)  
Old 04-20-06, 03:31 PM
Outlaw97GT's Avatar
Official Member
 
Join Date: September 2005
Location: Redneckville, Tx
Posts: 276
How much for the complete engine?
And for the heads/cams seperate?
Where are you located?
Reply With Quote
Reply




Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads

Thread Thread Starter Forum Replies Last Post
More progress, engine complete.. 94CobraPace Classic Tech 3 08-08-05 12:48 PM
Were to get complete gasket and bolt set for a 94-95 mustang? bjl95mustang 94-95 Tech 4 07-15-04 07:27 AM

 




All times are GMT -6. The time now is 07:21 AM.