[ukgtguy]

Does anybody know if it is possible (ie. reasonable without a lot of custom parts or fabrication) to install the Eaton blower, manifold, chargecooler etc from a 03/04 Cobra to my 2v GT (04) ?

My big concern (aside from a flash/tune for the setup) was utilising the Cobra intake manifold with the 2v heads.

The reason I ask is I have the chance of a Cobra blower including the following :

1: Cobra Eaton Blower and lower Intake

2: Cobra Intake plenum

3: Cobra Throttle Body

4: Fuel Rail

5: Injectors (8 count of 39#)

6: Cobra Throttle Cable (new)

7: Cobra Intercooler (under the blower)

8: Garrett Heat Exchanger

9: Cobra Lower Blower Pully & Bracket

10: Cobra Intercooler Coolant Tank

11: Cobra Electric Intercooler Water Pump (brand new)

12: Cobra Power Steering Resevour Bracket

13-19: All coolant lines for intercoolers and connectors (all are brand new)

[Gearbanger 101]

In a word....No. At least not practically anyway. Sure it could be done with a lot of custom fabrication, but it's going to end up costing you probably the same amount as it would, were you to buy yourself a proper kit for a 2V in the first place.

This question has been rehashed dozens of time. Put the "SEARCH" function at the top of the forum to good use and you'll find all kinds of useful information on the subject.