Mustang Forums at StangNet

tips on upper intake removal, 88f150, 5.0

This is a discussion on tips on upper intake removal, 88f150, 5.0 within the Other Auto Tech forums, part of the General Automotive Forums category; I have a used motor that needs the valve cover gaskets done so I need to remove the upper intake ...

Go Back   Mustang Forums at StangNet > General Automotive Forums > Other Auto Tech

Over 151,000 Members!!

Register Vendors Garage FAQ Calendar Search Today's Posts Mark Forums Read



Reply
 
LinkBack Thread Tools Rate Thread Display Modes
  #1 (permalink)  
Old 12-27-08, 10:44 AM
racer_inboston's Avatar
Founding Member
  
Join Date: February 2002
Location: boston, ma
Posts: 281
tips on upper intake removal, 88f150, 5.0
I have a used motor that needs the valve cover gaskets done so I need to remove the upper intake plenum. I know that there is a stubborn bold in the middle, anyone know what size or tool is best to remove this?
Thanks
Reply With Quote
  #2 (permalink)  
Old 12-27-08, 07:39 PM
racer_inboston's Avatar
Founding Member
  
Join Date: February 2002
Location: boston, ma
Posts: 281
i'M ALLSET, EASY JOB, BEEN 10 YRS SINCE i LAST DID UN UPPER.
Reply With Quote
Reply




« Anyone ever swapped over a fuel injected Ford 300 CYL in an older carb vehicle? | taurus wiper problems »
Thread Tools
Display Modes Rate This Thread
Linear Mode Linear Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 




All times are GMT -6. The time now is 02:35 AM.

Contact Us - StangNet.com - Archive - Top