View Full Version : 5.0 Tech
- Fuel problem diagnosis help
- Head Upgrade reccomendations for a 351W
- Strange brake bleed problem...
- Question on clutches in 5.0s
- msd digital-6 location
- BUMPSTEER SETUP
- Oil in my intake???
- ? Installing a walbro 255lph inline fuel pump ?
- ignition problem
- Thermostat Will NOT Seal PITA
- Heater hose fitting thread size?
- Master Cylinder Reservoir, replacement?
- Spark plug gapping and size windsor jr head
- Why is this so hard??
- 6g alt swap
- oil pump shaft problem,HELP!!!
- Driveline vibration
- Drilling Plug welds On Rearend Housing?
- fuel injector?
- any experience with the edelbrock rpm 2??
- Help fuel pump question?
- cobra Intake install' how hard?
- weight reduction help
- My car keeps stalling.
- How much can a v8 world class t5 handle?
- mass air
- Car shuts off when trying to do KOER test.
- Do anyone know where....
- Wheel Spacers?
- Cast vs Alum....combustion characteristics
- ACT sensor- who, what, when, why and where?
- fuel pump pressure question?
- New starter has only 1 prong?
- Question for all you sumped tank guys
- Adjustable Fuel pressure?
- Cold Start Problems
- may have ruined balancer bolt hole threads... need suggestions.
- 3.8 bellhousing
- Fuel Rail Help.
- Engine Build Help
- How much power with exhaust?
- Which size Head gaskets do I need for a 331?
- valve lash adjsutment
- How to determine proper fuse and wire size?
- cold air intake...
- Fuel Gauge always Full
- Rear Brake Change problem -ASAP
- EFI to Carb Conversion
- Whys my timing locked out to 20?!?
- new starter, new relay, new problem
- push rod length?
- Airflow Specialties alum heads
- Power loss, weird idle, and temp goes up
- NEED ADVICE
- NEED ADVICE
- Odd heating/blown head gasket?
- 14psi blower questions?
- Installing caster camber plates...
- transmission problems
- carb swap
- 351 swap questions. cam help
- boost level changes
- Removing Rear Interior panels on GT for 1/4 window install
- Radio Problems ????
- new swap won't start----help please
- push rod help!
- I opened my motor. Does this look ok?
- Newbie question
- windage trey and girdle????
- Does anyone know how a.........
- Which will have better street manners: E303 or F303 cam? Something else?
- Nitrous, turbo, blower AFR's
- heads/cam
- Forged or not ???? that is the question
- main cap sequence
- For those of you that cars run like crap for a min then clear up
- Need help on properly installing SFI Balancer
- Smaller supercharger pulley
- Battery drain, help please
- Moroso oil pan/dart
- Red Top Optima
- Neutral Balance
- IAC/IAB
- What is this hole in my block for?
- What is Operating Temp for 87 Gt?
- 98 brakes on fox-what brake line adapters do i need???
- Fuel pump?
- Really really P.O. New problem NEED HELP!!
- do i have everything I need for rear disc conversion?
- What tires?!?
- Just dies.......
- E3 plugs for Fox 5.0L???
- fuel pump eccentric and camshaft ?'s
- finally bought wheels aaaaand now they dont fit!
- Can anyone verify my diagnosis?
- Oil pressure gauge
- New Guy-New Car
- Spark plug #s for GT40s?
- rear brakes
- 70 mm tb, cobra intake, and different cam, Worth IT???
- Laurel Mountain Mustang Drag Spring kit question
- Pro products t-body
- 1990 5.0 problem. Please help
- aftermarket engine block and head question
- Rear Quad-Shocks 1989 mustang
- C4 Converter
- RAG JOINT
- Intermitent power to fuel pump
- 4.6 swap information
- wasnt too satisfied with the first drive.
- Valve train question
- where is my starter solenoid?
- Lights dimming at take off
- wiring issue, car wont start
- AC Delete??
- 03 Cobra braided lines on a fox
- think it would be worth it for me to get some twisted wedges?
- Info Needed
- Looking for a used enkie wheel
- Twisted wegde heads Stage II cam PTV clearance?
- Stroker Kit Choice - Dished or Flat Top..
- Where is the Computer in a 1990 Mustang?
- Which ignition system to go with?
- t5 removal
- Going with a Supercharger, Have Some Questions...
- Who has to have emissions test done with a 347?
- Adjustable Clutch Quadrant Issues...
- VERY BAD BELT PROBLEM
- 347 Build - Cylinder Head Recommendations?
- Getting ready to replace head gaskets...any tips?
- Help with this calipers
- Water pump and crank pulleys dont line up.
- what do i need to convert to MAF
- speed in trans
- R302 block???
- Engine / Hood Clearance (92)
- 17x10.5 on a Fox??
- 1986 5.0 HO possible fuel problem help please?
- gt40 intake gasket question
- hurst line lock install....
- RHS head question
- Quick pull when brakes are applied then goes away
- My new gears
- autolight #24
- 5.0 driven gear w 3.27
- Just ordered a pms
- DIY Convertible Top repair
- head differences
- Lowering Springs and shocks
- Compression Ratio
- 408 or turbo for high alttitude
- need to know a belt size
- NEED HELP WITH THIS?
- o2 extension?
- Flywheel Choice, Balancer Choice, and Tranny Advice..
- When to rebuild the bottom end?
- who makes the brackets sn95-fox?
- tank gas leak how can i fixed?
- Dim headlight on one side.
- ? about amount of HP my car made
- Which headlight switch wire to tap into?
- Ticking BADly!!
- Black satin paint questions
- 460 build???block pref.
- What size mass air for this setup?
- oh crap.....
- DIFF. IN DISTRIBUTOR AUTO AND MANUAL ON CARBED FOX???
- 33 spline axles ???
- T5 Bellhousin WC VS 3550
- rr ajustment
- My 5.0 will only run in open loop...
- 91 coupe trunk pop problems help!!!
- Electric fan wiring???
- What should I do about a transmission?
- Brake reservier wiring ?
- Intstrument Pane / Guage Lights do not work???
- Cheap manual steering???
- Weird electrical problem
- water pump leaking bad but not out weephole
- how would this rickflow item strengthen a stock block with stock internals?
- Need some help with my new oil pan!!!
- User friendly tuning software?
- No dash lights/exterior lights, but still headlights?
- Will the computer learn my new setup?
- Ribbed WP pulley
- Engine runs weired......Please Help
- Fox tire question`
- DCC fan controller not workin+other weird problem...
- 88 Mustang GT o2 wiring problems.....
- '87 LX High Idle RPM
- Side exhuast for fox body?
- rough idle?
- cobra r brakes
- A/F guage question
- WTF!!! Springs
- Intake Manifolds R vs ... RPM ???
- 88 Convt. Quarter Trim vs. 90+ Quarter Trim
- question, surge, dropping oil pressure, losing coolant
- Dashswap pitfalls and worries and advice please
- TEMP SENSOR Q??
- Tachometer screwy
- Maximum Motorsports control arms vs UMI
- 1.7 RR help
- 05 wheels on a fox...tire question
- paint code
- Will oil pan clear main support?
- Question about thermostats.
- 89GT w GT40x top end kit
- Power steering pump leaking....
- GT-40's
- mass air sensor???
- REAR gear lube capacity with girdle cover?
- 1991 gt Not starting ??? Help
- Blower clearing cowl hood?
- Fox Speaker Upgrade
- hydroboost install
- top end kits for stock motor
- Yet another problem
- Turbo Coupe Caliper rebuild
- Will the T5's from the newer V6 stangs fit?
- dead cylinder
- What kind of heads do i have?
- MAP question
- rear suspension
- 4" Mach 1 Cowl hood???
- Order of engine mods on 92 5.0?
- Gauges not working properly
- Mak's AOD to T-5 conversion.
- Putting on new power steering rack/pump, what size hoses do I need?
- Speedo Gear
- Is this a good deal?
- Axle Upgrade Question
- Alternator question
- Speed density nerds only please!
- Cleaning out an Explorer intake and vacume line question?
- who makes a rear coilover kit?
- DIY Shortend Axles ??? Anyone
- Help.......Codes 22, 44, 94
- '91 with no A/C anymore
- Help with 8.8 rear
- Very odd starting issue im having
- T-5 to T-3650 swap
- FMU or AFPR?
- speedo gear calculator
- Bad P/S pump?
- How to
- Low Oil Pressure
- car stalled this morning
- Oil Pan Gasket Change - Prime Oil Pump?
- Speedometer cable leak.