View Full Version : 5.0 Tech
- 94+ Gauge Cluster in 5.0? Anyone try this?
- Failed Emissions On A Truly Grand Scale...
- Need some help...car running terrible
- Downloads for 84 Central Fuel Injection?
- ST. Louis Stangers I need tuning help???
- Turn Signal & Back-up Light TROUBLE
- cant get into gear! Help!
- AOD work in place of C5?
- Whine in reverse/vibration at speed
- starter acting up...help!!!
- Anti-seize vs. Thread lock?
- MAf i think.
- ignition starting to act up
- door panel upgrade
- How much power for this setup?
- new computer?
- Hate my car!!!!!!!!!!!!!!!!!!!!
- 1990 Wiper pivot removal?
- Aftermarket blocks for roller 5.0 setups
- Hypothetically Speaking......
- tranny or converter???
- D & D rear coilover kit
- msd install
- PLZ HELP, I NEED TO KNOW ABOUT THESE GT40 HEADS
- Carb Runs Rich Until I Pull Of The Vacum Line!!
- What size fuel lines do I really need
- what fuse location and alt. wire question.
- explorer intake bolts
- Fuel Pressure Question
- Transmission...what to do?
- Are longtubes really worth the expense and hassle?
- need help car mustang wont run
- IAB or IAC
- QA1 10-way adjustable struts?
- Lightning mass air
- Wedge Engineering Seat Backets...anyone use them???
- 93 Cobra Rear End Install
- *Canadian Transmission Shops QUESTION*
- So when a dipstick tube breaks off flush with the block...
- 2 HEAD GASKETS BLOWN.....WHAT GIVES??
- What size injectors are enough?
- Guessing approx. HP-1/4 mile
- trick flow cam question
- which rockers
- Pulled codes.. need to know how to fix.
- No electrical power at all! Need help...
- How much psi is my supercharger putting out????
- Neutral safety switch(the one on the trans not clutch pedal)
- 347 Stroker beginnings?
- Foglight lens fell off...
- Rods and Lifters...
- helpppppp
- cpu question
- Spring Questions
- what alt. is this and how many amps am i using
- Bogging
- Lifters lifters lifters............
- Which plugs to run?
- Whose got a battery in the trunk?
- turn signal indicator and markers not working
- which way to wire fan,thermal fan sensor
- 351W rwhp guess?
- Fuel pump relay still warm after changes...normal?
- heater core removal
- Need a website
- wont idle with clutch in
- Need help with Boost Guage install
- quick MAF help??
- smoke then dead...
- BIG WIRING PROBLEM PLEASE HELP
- Rubber vs Poly vs Solid Motor Mounts
- Headrest Cover Install...How the heck....
- 3G Alternator
- Weird Clunk
- Fuel level gauge
- 351M, 351W, 351C, what's the difference?
- Needs some pics/ suggestions for 351W
- quick converter question
- A lil help please? :)
- not starting anymore
- help buildin up the baby
- Just got my first project,need to know if anyone thinks i have something to work with
- How much power should my new motor make? I'm hoping 340-360hp??
- Need help think I'm f'ed
- where do i get this part????plz help
- Thumper Heads
- Parts Pics
- Catted vs. Off Road X-Pipe
- Rounded starter bolt
- TOKICO adjustable shocks plz respond!!
- installed coil overs have a ?
- need help I.D.ing a wire..green with black stripe
- help removing cross-member
- how to lower compression for turbo (shims?)
- New to stangnet first question
- Nitrous HELP
- 1988 GT electrical
- Another but slightly different electrical question
- GT40Y303 and 331??
- Any proven E-fan controllers besides DCC?
- 95 5.0 is super slow! Why? Please help!
- Fuel Neck Removal from Fuel Tank
- question about timing
- Having trouble shifting
- squeal and smoke
- Quick T5 fluid question
- suspension swapping
- idle problems
- Same problem again!
- fuel press reg
- What oil ?
- Firing Order
- Need new headlights
- T5 Tranny Noise ???
- Power loss above 3K
- anyone ever use this????
- White Face Gauges
- couple questions about matching engine parts
- Will a mechanical fuel pump work?
- K-member Quick questions.
- occasional starting problem ??????
- the best is not working
- Could this cause a bad vibration?
- 84.5" short belt?
- lost a fitting for the mechanical temp gauge.
- Change from Synthetic oil to conventional.
- 24s or 30s
- HELP! Idle problems!!!
- doesn't seem to idle
- come on need help pro m
- OVER HEATING ???
- t-5 tranny question
- and now the heater core..a 85
- header steering shaft clearance
- 94 trans
- headrest removal
- IAC? god this is frustrating
- 95 cobra quiting when driving down the road
- FMS Oil Cooler Mounting!!
- went to the track.....
- Overheating... best fan
- Front Brakes "sticking"
- A couple questions for my dad
- Power Mirror Disassembly
- Fuel line + exhaust is no good...
- What weight oil for tranny?
- gauge cluster question
- Removing outside door handle rivets?
- TPS VOLTAGE
- Help! Trying to remove rocker panel trim...
- car wont start????
- 315 in the back(tires)
- what fuel presure for 24lb injectors
- Tranny swap Question
- What is this hole? (pics)
- HELP brake issues after 5lug conversion, bled brakes 100+
- DYI turbocharging... whats it take??
- Sold my notch and bought another
- "shakey" starts
- Worth it ???
- new parts: car wont start
- Please help me!
- Anyone familiar with buying impounded cars???
- 104 octane
- what to do with a DD, high mileage car
- O2 sensor question
- what cam?
- Fox AOD T5, Same Exhaust System?
- vert 1/4 windows wont go up
- 85mph speedo upgrade
- 1/4 mile
- which valve covers clear
- first start motor troubles...
- SN95 5 Lug Swap Thread
- Valve spring keeper issue?
- Hood will not release after hood install
- Radio install
- Modified TKO 500 (MMR PT750) installed. First impressions
- 85 Mustang GT HO problems
- Advice/SD/MAF
- Pro Products Intake Manifold Typhoon
- NEED axle bushings in ARIZONA!!
- Manifold Hoses???????
- No Mufflers?
- 351W Waterpump and Serp. Help Needed!
- Oil weight ... what to use?
- Cruise control? need help....
- One Last Problem and she's ready
- problem or not
- Speedometer - ticking/squeaking behind dash
- autometer dash pod ?'s...anyone have one
- How much compression is to much?
- Please help with Charcoal Canister
- will 91 cluster work in a 89?
- sn95 fox transplant
- pro m size question
- New Pics & Video of my LX
- SLOW TURN SIGNAL BLINKERS
- Dumb C&L Question.
- Is 4cyl & 5.0 stock A-Arm the same?
- Short throw shifters worth the cash?
- Knocking Noise please help
- Broken E-brake cable
- Brakes feel spongy after replacing rear hardware?
- Advice needed...sort of long
- Rear main Seal
- Swapping Wiring Harnesses???
- 50resto weatherstrips....leaking.
- Timing Questions
- Leaking Air Conditioning System
- water pump pulley bolt size?
- My brakes suck big time..help
- Going to look at a 90 GT in a little bit...
- which one is it, 50 or 28 oz. flexplates.
- Coolant/Temp issues
- Cooling issue
- opinions on this front end swap
- How to check for a bad balancer?
- Installing new cam...TDC?
- Ticking Noise!!
- x-pipe for long tube question.....??
- x-pipe for long tube question.....??
- Anyone ever greased their convertible joints?
- strange shaking/vibration
- Installing Intake/Exhaust valves hard?
- what needs changed to put explorer motor in 95 stang?
- Getting code 95, anyone had this?
- GT40 GT40P's?
- Fuel pump prime-how much pressure?
- Air Injection?
- Need H/C/I combo for 11's
- C6 trans in a fox?
- New Fuel Pump Install Question
- race pulleys
- need to know ya know.............
- Is there a difference ?
- need some to check my temp #'s
- Autometer Gauge Install Help Needed.
- High RPM Vibrations
- Took Off Center Cap And Heres What I Saw HELP
- how to put efi 351 heads on efi 5.0
- police oil cooler location?
- welding in O2 bungs.
- 1/8 mile results
- Build up
- Just spun the 5.0 onto a medium/island what damage should I look for.
- tranny question
- Low Collant
- Smaller turning radius with new rack?
- paxton s/c install