View Full Version : 94-95 Tech
- Help w/ ford's POS recall
- Side EXHaust MUFFLER HELP
- Anyone install a C&L 76mm TrueFlow MAF System on a basically stock '94/95?
- Clutch Question
- Tranny Process
- How should I go about this?
- Need wheel pics or photochop, i'm getting desperate!!
- anyone have pics of aftermarket hoods on their cars????
- Power steering relocation kit for going 302 to 351..where?
- Where to find Lazer Red paint?
- Need to find someone to port lower intake
- What Pizza Cutters would go with my car?
- BBK o/r H piped for long tubes question
- front end steering rack replacement
- If you use hood pins, do you need a hood latch?
- and the ups guy shows up again.....
- Does my car need a tune, Don and everybody else?
- Fox tubular k-member.
- 2nd opinion plz..this would work for testing brakes right?
- Need help with pulley sizes (347 w/s-trim)
- 94 Cobra with 15X3 Welds Help!!!
- Clutch and Flywheel
- strut tower bolts are stripped need to fix them how?
- New to GT40's...
- why no holleys?
- Will my Trick Flow 170cc intake runner 61cc chamber work well with 408ci?
- FOB keyless entry I cant find the right one will another work?
- Blue oval ind. control arms???
- daytime running light module ( again )
- Harmonic balancer questions
- Ford Sportsman Block?
- fog light question..
- 1/4 w/ the auto
- What gears and from where?
- Those using Tremec and D/S Spacer come in
- will i need a tune? (asked a lil different)
- Cam Questions
- filter question
- Another exhaust question
- Has anyone ever installed a rear main seal with any success (no leaks)?
- windsor jr / cam
- Would it be worth it?
- Does anyone know of a company near MD or PA that sells these hoods?
- Supercharger or Turbo???
- Overheating problems
- Look what I stole today!!!!
- qucik question
- How Can I Fix This?
- Kooks Header Guys Please Help!!
- Mach 460
- Is a canton oil pan req for 408 to fit our cars?
- Tune by Chip
- Attacking the powersteering
- Best intake for 95 5.0
- another 1/4 mile question
- stupid q's on intakes
- Reverting back to stock
- Suspension Kits
- lowering just the front?
- E303 Camheads in here.
- My car doesn't start, acts like a bad battery but I dont think it is.
- will this shifter work?
- Valve Cover Bolts
- King Cobra kit...do i need anything else?
- Roll bar and a few other questions
- Would a cobra 75mm stock MAF be beneficial to my GT?
- Anyone have SLP Loudmouth...which ones better?
- car stalls after longtubes install
- Procharger fitment with 351
- pro-m mass air meters
- check engine light (not a mustang)
- Those with 2000 cobra r brakes
- ABC Exclusive Saleen Hood problem
- What is the electronic box inside door? Remote Entry?
- Thottle body question?
- Suspension Problem
- Intake help!
- I live my life a 1/4 mile at a time...
- Super Charger Help?
- MAF location for turbo
- camshaft dowel length?
- I need help! I dont know what went wrong...
- TKO Woes, And I Don't Even Have One Yet
- need cold air intake advice/tips
- how much is my T5 worth?
- Comp XE274 with AFR 165s and stock bottom end?
- MSD 6A with iridium plugs?
- Looking for 325 rwhp. Help!!!
- need answers before buying headlights...
- Hesitation and stalling
- IAT sensor thread size. HELP!
- Ok where can I get this? We found it a while back, but I lost it.
- Compression test results
- 86-93 t5 driveshaft
- cruisin studder step
- cruisin studder step
- anyone runnin ebay rotors ur stang?
- switching calipers on my '95 to the '99 up pbr's. which ss brakelines to order?
- Relocate power distribution box?
- clutch forks
- Bolt size to put a stock block on an engine stand?
- motorcraft alternator who sells them?
- starting issues--ignition switch?
- keyless entry problems?
- why does my friends car die when cold? (not a mustang)
- door lock wont move
- Hoosier 27x10 full race slicks. I have some questions.
- Carb Lower Intakes With Injector Ports?
- Do summit seats fit fine with the sliders they come with?
- Homemaid 2-stage Boost controller
- royal purple in my car
- Nitrous Walkthrough/Advice
- ABS problems
- Rear coil over kit ?
- Catted midpipe anyone???
- Trick Flow Intake
- Found New Brake Caliper Mod!
- A-Arm inter-changeability?
- Heater problems
- Need new gaskets and....? going turbo soon
- Is this a good deal on an engine???
- Tan interior-->black summit seats, black carpet....
- Power Window Works Once Then Quits
- sputtering while accelerating
- So many shifters
- motor has 120,XXX, need opinions on rebuild!
- Opinions on these pullies and smog elim
- Tickety Tachety
- Cobra R Intake Manifold
- Porting MAF?? good or bad?
- iddy biddy hole in rad im guessing
- few questions
- Are the '94-'98 brake pads the same for the '99 & up Stangs?
- SoCal engine builder?
- Are the '94-'98 brake pads the same for the '99 & up Stangs?
- Are the '94-'98 brake pads the same for the '99 & up Stangs?
- 95 Cobra advice needed
- 347 DRIVEABILITY...any good?
- will fox headers work
- Easier way to change oil pan gasket
- Jump starting error...99 Pathfinder
- Geting E7s poterd
- Touching up painted Cobra R rims
- valve cover question
- Brake upgrade question?
- Are these headers Junk?
- AODE to T5 swap??
- Grounding Kit
- Best cam for the job?
- HELP!! I can't get my Tweecer rt connected
- did a break my input shaft?
- Any NA 94-95 CObra owners here running tweecers?
- custom driveshaft for sn95/tko600.....
- Bellhousing Bolts
- Does not start AGAIN, HELP!!!
- NEED HELP NOW!!!
- Airbag Delete Panel?
- HEY GRADY... are you using stock rocker arms
- 275/40...will it fit?
- Major electrical prolems
- Brakes failed!!! SCARY!!
- best AODE option
- Do GT40P heads cause a check engine light?
- can i run high 13's?
- pro m meter q's
- factory tach....way off?
- Sumitomo 315's....Reviews Please
- Battery screw up
- What Harmonic Balancer should I get?
- Cost of painting side view mirrors?
- Brake Line caps
- 315/60/15 Mickey Thompson Drag radial on a 94 Cobra???
- How much is to much for GT40 heads?
- 24's enough?
- Bad vibration at 80+ mph
- headgaskets for a 306
- Finally Another test Drive and BOOM
- Gingerman track day pics from OCt. 2006
- Possible distributor noise
- New Exhuast setup is done, almost!
- 245 mm tire on a 9 inch rim?
- 393 stroker in a 94 cobra
- Can you make INJ act smaller?
- Is this a bad install or just a cheap clutch?
- Is this a good brake upgrade deal?
- Is this a good brake deal?
- Installing fuel pressure gauge
- svo extender
- installing new headlights
- what do you think about these heads???
- Tensioner Pulley?
- cam headers....
- Questions on EGR Valve?
- Does anyone have WheelReplicas 17x10.5" ANTHRACITE Bullitts in stock?
- installing a tri-ax
- 95 cobra springs
- 94 Mustang starter problems
- Eliminating PCV System
- pushrod ?
- Battery keeps dieing! Help! - 95 GT -
- Multi-layer steel head gasket
- 4.6 swap
- Help!!......Please
- Funny exhaust
- all you TREMEC TR3550 guys:
- another AODE shuddering
- Eibach Sportlines?
- Question on o2 Sensors...
- Just a quick question on these things...
- Putting IAT in the MAF
- mach 460 wiring question....
- Oil out the dipstick!!!
- Forging my block
- I need suggestions on a complete exhaust setup
- 94 top speed
- Help me build my Suspension $1500
- Your Advice Appreciated!
- rear sway bar...needed
- Aluminum Flywheel
- Few Questions on this supercharger
- another side exit exhaust question??
- shifting issue
- What Clutch are you 650+rw guys Using?
- Check out my dyno graph and let me know what you think!
- Some drivetrain Ideas
- What's the diff between 5140 Machined Beam Rod and 4340 Ultra Light Weight I BeamRod?
- H/C/I fuel system upgrade
- Locks acting up
- Ignition again ???
- Clutch cable question
- Alternator taking a dump?
- which intake manifold from tfs????
- Quick CAI filter mount questions
- thinking about changing combo.. Help!
- Water Pump gasket
- So.. if I went kenne bell, how MUCH HP can I get with 10:1 compression?
- Bad Starter?
- recommended parts with sportline install?
- rearend help
- I need some help with what to do?
- Gutted the Cats Found another problem...
- What rods do I have
- Bypassing factory amp?
- I'm looking for intake flow comparison chart
- Camshaft Help...
- Stock head specs?
- Fitting Subs In My Convertible?
- transmission
- what color is this?
- New carpet and sound/ heat deadening?