View Full Version : 94-95 Tech
- what color is my car
- 5.0 mods for like 500. Have a lot done.
- self alignment
- clock pod gauge size?
- boost gauge questions
- Lightweight rims?
- Anyone ever put a top on?
- Welds on a 94 Cobra?
- clutch pedal is HEAVY
- Need rear brakes help FAST!
- kenne-bell noise
- 94 GT with Exhaust Leak
- Couple of Questions...
- Lower control arms
- Will I ever be able to know my mileage?
- grinding into 3rd, only hard shifts
- How do I disconnect my fuel spout?
- took car to get alligned......
- Should i move up to wolverine 1087?
- cooling fan - where to buy?
- killing belts!!!! help!!!
- Cobra help
- bbk long tube headers and smog equipment fitment
- KB charger on a stock '94 GT, can it be done?
- abs delete problems
- Does metal have to be polished before chroming?
- removing quad shock
- is this supposed to be here?
- 87-93 MAF on 94-95
- Loc-tite on aluminum heads
- What does Index the bellhousing mean?
- Help me identify my spoiler
- sportsman block worth the extra $$$$
- Problems with my car
- Ebay Chips
- Gauge Sizes (clock pods)
- Grady, Joe , Anybody- Which MAf is needed?
- Brake pads
- Fianl verdict: Mercon V or II/III for AODE?
- Torque the top head bolts more than the bottom?
- Oil Pressure Gauge won't budge.
- Throwout bearing constantly going bad.
- H/C/I emissions questions
- 8.8 diff
- Back pressure missing, how much I'm I loosing?
- Death of a lifter or lifters?
- Drivetrain noise
- Problem checking p-v clearance with our lifters! (long)
- Whats wrong
- saleen door fillers
- Loud knocking noise
- water temp gauge
- New wheel spacers on (pics)
- Quarter Panel Question
- New control arms M3075D
- What RVT?
- HELP!! Key broke off in ignition!
- check engine light on
- lost my keys
- 1994 351 Project Question!! please help!
- Clutch Slipping?
- New wheels are in! (PICS 56K Warning!)
- rest of exhaust
- base idle
- Need help with timing gear set!
- When is an aftermarket starter needed?
- 130 amp to a 200 Amp alternator
- DA' 8 INCHA-10rib Custom Vortech 94-95
- Anyone tried this?
- Dies at Ideal
- Should I paint my door bezels black or Vibrant Red?
- Grady clean out your PM's...
- Finally started my motor (Vid and pics inside)
- Stang overheating ??
- Snow performance methanol kit?
- Push rod length?
- oil pressure sending unit
- A few exterior questions....What do you all think of Saleen Bezels?
- Battery light is comming on when idling????
- 13 inch rotors
- lm-1 vs calcon
- MAF transfer datalog for Tweecer
- BRAIDED STAINLESS RADIATOR HOSES?
- my brakes went out
- header gasket question
- Help Nacho
- Question about blaster coil
- What intake gasket should I get???
- Spec Clutch Question
- Tire help!!
- Front higher than the back?
- What's wrong with my car !!!! (Help)
- Remember how my car stopped running back in the fall? Well.....
- quick ? about vortech..
- Cam Question..
- New Aluminum Driveshaft Question?
- Sticky Idea: Rims, backspacing, tires - if you bought them, cmon in
- o2 sensor question.
- ABS Light
- With a Kenne Bell should I have the FPR hooked up to boost or vac side of blower?
- what rims for my car
- Ordering Intake: Which Finish?
- anyone running nitrous?
- rear seal
- psi 315s & 255s
- ABS Came on
- Made a lot of progress tonight
- FMS 3.73 Gears in!
- Remanufactured Distributor or Replace Stator
- MAC Fenderwell Cold Air Intake
- pcv question
- Does anyones elses car spend along time to Cranking?
- battle boxes,where to buy?
- King Cobra clutch problems***help***
- What spark plugs for aluminum heads/supercharger?
- Blowing out spark? What to gap my plugs at? (Miss at higher RPM's)
- 17 months later, my car is RUNNING!
- car dies out
- Dimensions of a GT40 and Trickflow for STB?
- Fan doesnt shut off??????
- AFR 165 head questions
- need some t-body help guys
- Aftermarket Strut Tower Brace For My 95?
- Need flange for custom exhaust, Summit not providing...
- How reliable?
- Mac Cold Air Intake
- Any one running Amsoil tranny fuild in there T-5.
- Trickflow intake install question and Professional Products adapter
- valve stems for wheel replicas
- Pictorial Guide to Odometer Gear Replacement
- Supercharging Headaches... Before Purchase!
- Aspect Ratio for Front
- Questions About Pro-M
- fox mass air
- changed my oil pan gasket on saturday.
- newbie egr question
- What Specs to look for when buying AL heads for a S/C cobra..
- Handbrake cable jacked up
- WTF Happened to my car?
- Longtube install Q's
- belt keeps flying off!!! help
- Used GT-40 intake: How to finish?
- Heads and Cam Question
- stock gt40 max lift
- T5 Swap Complete - Speedometer is jumping
- car died
- Stator Help!!
- CHEAP PLACE TO GET A BLOWER?
- wheels spacers for bullets, what size do you use?
- Those with adjustable shocks/struts come in...
- Made Oil Seperator for less than $25.00
- valve cover baffle ?
- I duno why my car is doing this.
- Mystichrome Paint on an SN95??? Pics? Anyone seen this combo?
- anyone know what size belt for bypassing A/C only?
- Polished Rims
- Fuel pump install help
- Have extra cash for valve springs and rockers.
- Removing riveted bracket under console for carpet install?
- Shift points and speedo
- best supercharger for 95 cobra?
- Need ignition cylinder
- venom 400 Question
- window lift bushing
- is this Edge TC a lock up?
- throttle body question
- Wheel Spacers
- Starting issues, electrical gremlins
- Problem with MM firewall adjuster and adjusting it
- thinking about bypassing my smog pump......
- Rear main seal question
- Need Help, How to monitor oil return flow.
- U/D Crank Pulley Only....
- new king cobra clutch and trickflow intake installed
- Check this!
- S/C Install finally started
- opinions welcomed, buying used roller rockers
- Are 98 OEM Cobra rims Aluminum?
- A little twisted.
- quick question about side view mirror
- Compression results, thought I would share.
- Best subframes to get?
- Oil in Coolant but no Coolant in Oil
- Want my car to HOOK!!!
- SMOG STUFF ON BACK OF THE HEAD?
- smog tube
- Choices for Shock Tower Braces
- Engine Codes... Runs
- can a computer be tested?
- Fed up with Cometic MLS HG's.... Any suggestions?
- Late Xmas Present *Pics*
- Doin some work on the car tomarrow...any words of wisdom?
- Aftermarket Aluminum Radiators for 94 / 95 cars?
- just bought a 94 cobra......did I get a good deal??????
- 4.10s not good on 5.0 motor ?
- POST HERE IF YOU DRIVE AN AUTO
- AODE is out! A couple of questions.
- Those with 13" Cobra brakes get in here! :)
- Dammit! Need new Master Cylinder. Will 2000 V6 Stang work?
- Massive Exhaust Leak
- some kind of leak
- Should I buy a '95 GT?
- 02 sensors
- JMS Still Doing Autologic Chips?
- Selling the project...need some advice or opinions
- Brake calipers, NEED HELP asap!
- Need a little help..clutch??
- heads and cam question on 95 cobra
- lowering, THEN c/c plates?
- what causes popping out of gear?
- I need help again guys
- WTF Brake caliber bolt??!!!
- 93 cobra TB
- 15 x 10 Pro Stars...Good fit?
- Good source fo a custom burnt chip?
- hesitation and low charging
- Freeze plugs popped out....
- Another one of those valve cover questions
- NEW 5.0 DART BOCK,CARBS OR INJECTION??
- Popping noise when engaging the clutch
- Replacing front suspension, what to get?
- oil leak?
- Fuel question.
- head bolt replacement?
- 351W SWAP!!!
- Which 7qt. oil pan for a 351w?
- Finalizing the list!
- Steering, Alignment Problems.
- Help. Bench Bleeding M/C.
- cobra brakes on gt question...not a tech question.
- cobra brakes on gt question...not a tech question.
- HELP ME fit my body kit
- Hitting rev limiter with AODE
- MSD 6al problems
- innovate wide band worth it?
- Gauge pod in mach460 cd player location?
- Someone with diagnostic Knowhow...PLEASE
- 347 Guys, Help Me Pick One!
- QA1 A-arm and QA1 k-member alignment help
- IM SO PISSED YOU HAVE NO IDEA! HELP ME!
- Is there a slick out there for a 17x8 rim?
- Jegs Seats installed!
- how to check if a chip has been installed?
- oil problems
- What do yall think about this set up?
- How to datalog A/F with CalCon/Tweecer?
- My turbostang is ALLLIIIIVVEEE!!!
- where to get wheel spacers?
- Draglite backspacing?
- Alternator squeek