View Full Version : 94-95 Tech
- Why is my car pinging!? grr
- C4 Swap information?!?!
- Installed MMR front coilover kit today*MY COMMENT'S*
- opinions of NEW MAC catback?
- TFS Street Combo with AODE...
- got $8,000 to build engine/trans combo and need some ideas
- driveshaft
- Leather Seats
- pedestal mount rocker guys!!!!
- avereage HP from a 347?
- what size are stock rotors?
- turn signals/flashers having a problem?
- 95 Cobra Radiator Fan HELP!!!!
- Need the BEST Throwout Bearing out there!!
- Magnapack on a 94-95
- Does anyone do custom burnt chips anymore?
- Window wont roll up
- Edge Performance Torque Converter
- When removing the a/c, can that big grill come out in front of the rad?
- help with hew car!
- Aluminum Heads for under $300
- TCS switch (Transmission control switch)?
- Cleaning intake manifold with Seafoam
- How rich is my car? Flame throwing rich!!
- I cant get the car to idle well, just tried reseting the idle.
- Cam Question
- Is the any body with a tweecer in NY or NJ that knows how o work this thing??????????
- Painting Stripes
- will 315/35/17s fit in the back???????
- Which brand H-pipe Fits correctly?
- Intermediate poopyness
- power steering hose intall
- Cobra Intake Manifold Installation
- door window weatherstrip replacement
- Which computer can i get?
- Another Wheel Spacer Question
- big undertaking
- what size bore headgaskets?
- trans question
- Is Fix-A-Flat Bad?
- BOO switch?
- Cars vibrating, can it be my driveshaft or do I need to look elsewere?
- NMRA License frame
- guideplates for pedestal mound heads?
- EGR cap?! Where the hell is it?!?!
- Tweecer help and FMU question
- Tranny Shift Problems After Gear Install
- Question for you head porting experts.
- Low end is rediculous! Automatics must read!
- car idols up and down
- car spuddering...
- Tire Size Help
- Do you put silicone on the balancer/crank bolt?
- power steering quick fix
- Alternator dead??? Or what!!
- Safe RPM to shift at?
- Deleted my AFM Powerpipe = short issue gone
- Low Oil, and Low Oil Pressure
- SC kits fox vs 94-95
- 15 inch drag radials what size to get?
- Intake Manifold Install
- Car Shuts Down At 5300 Rpm
- tie-rod help
- Compression Ratio Question
- $1000 to spend, What to buy
- Bassani tips??
- CEL getting these codes
- Bucking/Surging/Dying question
- tonnenue (spellcheck?) covers on non verts?
- hi there, new to the forum
- WTF My Damn Seat Broke
- What would you do with $25k?
- transmission fluid help
- HELP I have melted vac lines....
- Cam shaft Lube hurt blower?
- qa1 coil-over kit, adjustable ride height?
- aluminum block
- ZeroRT's new ride
- tires
- For 94-95 Cobra Owners
- 295, 305, or 315 on a 18x10 rim
- Painted speedo needles
- 24 lbs Injector question
- Uh-oh, that didn't sound right...
- Banjo Bolts... I now hate them
- Help
- tuning options question
- How do you register the EEC Analyzer at .......
- H/C/I and supercharger at the same time?
- Where are your battery Cut/Offs?
- need new hood what are some good hoods to get
- Need some help - Check Engine Light - Trying to Sell Car
- 95 Cobra Intake Manifold
- 306+what= 325 streetable horsepower
- anyone know of any wheel spacers threads and where can get some at
- I need some quick help...car not starting.
- speedo not working after t5 swap
- guys how much should gear's and trq converter cost
- 95 GT brake problem
- Painting numbers on a balancer - question
- problem installing convert top
- temperature knob doesnt change hot or cold
- Similar Idle adjusment procedure??
- 42 lbs injectors
- Balancer installation question
- U Joint Replacement
- Anyone using UPR K-member kit?
- t5 wont go into gear with the car on
- car wont start after H/C/I
- 4.10's = awesome
- 93 Cobra Intake Plaque or something else?
- Weight?
- Rear AODE seal
- Can carb cleaner damage the MAF?
- LTs problems
- Tranny Woes
- Question about method for installing sub-frames...
- Flushing The Radiator.
- quick answers needed (cobra parts for a gt)
- rpms fall slowly when stopping
- AFR head and intake combo help
- Simple Header question...
- Negative battery cable smoking?
- Melted headlight switch plug
- o2 extensions for LTs
- Need help. Pro-M mass air to fender filter.
- Innovative LC-1 wideband
- Short Belt/Deleted Smog Question.
- charging question
- What size tire on a 18" rim
- 95 gt wont shut off
- Stock Intake
- Tweecer just came in :)
- Another problem - Balancer fell off. Suggestions?
- Electric Water Pump
- Should the upper intake ever be too hot to touch?
- Where to buy an OBD I scan tool with display
- Cowl Hood
- What vacuam line is needed for the A/C?
- New numbers with the port matched 75mm TB
- Fox boddies have a different radiator?
- Transmission Leakage question
- tweecer, what is it? Where can I...
- How hot is too hot?
- Laptop for Tweecer
- Where do i get a Crankcase ventilation breather?
- gas/exhaust fumes
- guage cluster problems
- Slight Rattle or Knock?
- 42 lb injectors - what MAF?
- Injectors differences and such
- Motor Build
- Vacuum Question
- problems with my march underdrive pullies
- What Throttle body should i get, and some more ?'s
- street heat/stock lower question
- Going Kenne Bell (again)
- 6 speed on a 5.0?
- Cobra and underdrive Pulley Question
- no strut tower brace
- Alternator fuse screwed up..
- How to tell if port was leaking?
- RIDE QUALITY with h&r ss and bilsteins
- cleanin air filter on CAI
- Mickey Thompson ET Street Radials???
- 3/8" intake spacer w/cobra intake fit under stock hood?
- DAMMIT!! Idle surge is back, bucking is worse
- Blower or Nitrous?
- Compat Questions
- Transgo shift kit on the way!
- 03-04 Cobra wing
- HELP?! Anyone!
- CAI install, rough idle....Help
- why in the H is my car busting trannys and driveshafts!?
- Fail Emissions
- questions about stock gt and cobra pulleys for 94-95
- Problem with stock , Autometer and Tweecer TACH
- hot start problem
- Rather than buy a new strut tower brace, modidify the old one...bad idea?
- Got a Vac. Tester, where does it go? HELP QUICK
- C&L causing my problems?
- Oil Pan
- Ford SVO coil fitment Question
- Are all 94/95's this slow? Help Plz!
- Maybe a common problem?
- All I can say is wow..
- Any experience with GT40p CCM-9495 header?
- Help me solve my power problem
- header questions
- Need Some Quick Help!
- Quick question... 2 or 4 o2 sensors?
- what the heck would cause this?
- Fuel rail hose
- Deleating powersteering and A/C questions
- Pinion Snubber + Sportlines... a must?
- Lower intake install tips
- WTB/WTT: 94-95 GT Automatic... Cheap! :D
- Anyone use the delta fan controller?
- Need help here!! Mach 460 related
- can anyone help me?
- Supercharger?
- HELP!! Electric Fan
- Sub-Frame install
- Can a wrong-rotating water pump cause strange cooling issues?
- 285s on a 9" wheel?
- Need parts!
- FINALLY!! She runs GREAT!!
- tweecer owners
- ebrake cable problem
- gearing different in cobra trans vs gt?
- trans problem.. no 2nd gear!!??
- Cylinder Balance Test results:
- Cylinder Balance Test Results: Need ideas.
- Finally found out the reason for chitty performance
- 302 Stroker Pricing Question.
- $11,500 to spend and looking to make my stang a 500hp daily driver, what should i do?
- oil pick up clearance issues
- belt is squealing, a/c + smog delete quesiton
- Got the tweecer to datalog! Got some questions, Grady!!
- Gear Time!
- Modded 95 vrs Modded 05 Dyno Results Inside
- stock 97 shifter knob fit 94 cobra
- A/C Line
- pushrods
- Failing tq converter?
- rims need help
- Pro3i LCA or the Granatellis?
- Another One....Thinking O2's (sorry kinda long)
- will this be ok?
- no more mach one chin spoiler???
- Check out my rack!!!
- Need help with some codes- Please
- magnaflow mufflers
- New Toys arrived PICS (and an offer on my car!!!)
- Evidently My Car Runs Like Crap?
- Coolant leak???
- thinking of buying a tweecer!
- fox prop rod work on our cars??
- Borla/SVO Side Exhaust Guys - Read - URGENT!
- All new suspension/ what to get?
- Back from the Dyno - What next?
- 94 GT not starting
- Pedal Assembly Pics - What Year?
- Noob ?
- Fox Body TB Conversion Questions
- is this right?
- Just got a edelbrock performer.....
- Turn downs to clamp on muffler?
- Upper Control Arm problems
- EEC or Tweecer? Which one is better?