View Full Version : 94-95 Tech
- Can I spreay a little bug and tar remover in the intake where the MAF sensor is?
- Hi speed fan ?
- Alternator....130 or 200 amp
- Whole lotta shakin goin on!!!!
- 1/4 Track Question and Weight.
- BBK short o/r h-pipe for LTs are the same for SN95 and Fox stangs?
- '94 Cobra and GT what are the differences?
- push rod length with new tfs tw's?
- Suspension questions, Advice needed.
- drivetrain vibration and other questions
- harmonic balancer?
- 4 bolt main?
- Help on getting a special tool?
- Your thoughts on DSS. short blocks
- Best Brake rotors for the money?
- I need a shortbelt length for everything except the smog
- Check Engine Code 332
- Nitrous Installation...?
- whats it worth?
- Are our alt brackets the same from the Fox bodies?
- BBK LT header question (routing secondary exhaust lines)
- full lenghts what to get
- Stupid $hit on this car is pissing me off......HELP
- mac u/d pulleys
- Good head for my 306/nitrous combo
- Pics of my new headers. Any install tips????
- Alignment question
- Head Experts?
- i THINK MY BRAND NEW 306 BLEW UP!!!!!
- fuel coming out of exhaust
- Car won't start
- ebrake light?
- OK to clean throttle body?
- Nitrous 150 shot on stock bottom end?
- will my ride get any smoother? bilstein owners help please.
- Best way to paint engine?
- Where exactly is the idle screw and how do you turn it? Did the search...
- Intake manifold gasket cut-away..
- Can't figure it out!
- Supercharging a 347
- long tubes on lowered 94?clearance issues?
- dissapointing night at the track
- vortech kit
- fuel everywhere,!
- Why does my car weigh so much?
- edelbrock performer 5.0 installation-craftmanship is terrible
- too much timing???
- Will these valve covers clear?
- went to track wtf happened?
- Symptoms of a bad/dead alternator?
- help before my car enters shop
- A side effect of it's MI origin?
- Catted ProChamber???
- Installed my gauges today
- Temp gauge problem after intake install
- Exhaust/Emissions experts please!!!
- Air Temp vs H.P. loss?
- Spintech Pro Streets > *.*
- Overheating Question
- Welding question.......
- Ripped out AC system
- Car burning oil......
- Car not starting...help plz
- Is it my CCRM?
- Re-Setting The Computer
- Weights
- BBK SSI Series Intake
- Off road vs Catalytic
- AODE Locked in Park
- Alternator?
- compression ratio question...
- buying intake hae questions on stuff???
- Going to change motor mounts, any advice???
- what would you do next?94 gt
- MGW shifter?????
- simple timing q
- Rear end clunks/noises...
- Will MagnaPacks work on our cars?
- How many 12 second cars with stock axles & diff?
- Is This Good?????
- well bought the MAC h pipe =crappy quality
- steeda stb installed
- Valve cover Help! needed ASAP
- egr question
- ive got bad vibration at high rpms
- adjusting valves - lifters pumped up or not?
- Bullit Suspension and Convertible
- guys with boost and #42 injectors
- Kirban AFPR Q.
- Headlight Short
- Where can I buy fender flares?
- Losing fuel pressure
- Does anyone know this?
- Anyone add 2nd O2 bung to Long Tubes
- MAC H or MAC X?
- Transgo Shift Kit
- popping under hard accelleration?
- custom cai
- break fluid disapearing
- Hood Pics
- do i need an FMU w/ s-trim?
- New 1/4 Track times
- What intake?
- Need help rewiring my horn
- a few mods, a few questions
- Difference in Track Heat and Twisted Wedge heads?
- advance auto clutch
- Really need help with MC here, please help me out
- msd ignition 6al module
- how much HP does your AODE take?
- Cooling issue, need electrical guys
- Old Belt Squeeks, New Belt Squeaks, WHY?
- Pulley install question
- Whos got a parts list for an engine/rebuild and/or head swap??
- Are all adjustable clutch quadrants the same?
- Bent valves?
- Another Pinging problem!! 20 dollar Paypal reward if you can fix it!!! No Joke!!
- Guage Install
- Removing brake distribution box?
- Adding Cats to OR-Hpipe
- Need help with Vortech S-trim.
- Trans won't go into bell housing fully! Keeps stopping with a 1/2 inch gap!!
- Seats that interchange - 94 GT?
- Anyone know how to fix THIS??
- C&L MAF
- Which trans to go with for my 95 GT
- Bullit pedals
- Clutch Quad Install
- could a vaccum leak cause a loss in power?
- Good news guys! I have crappy compression!
- Power Curve Flattens out at 4500 RPM
- 190 or 255 Fuel Pump
- clutch replacement, what to do about flywheel
- Car is running, but exhaust sounds bad around 2200rpm
- long tube headers or performer manifold?
- Any experiences / opinions on Baumannator?
- Engine Stand Mounting
- hidden wires
- 95 cobra and 95 GT motor dif.
- Car is having problems starting :-(
- Final purchase before school!!!
- wheres my spout?
- What intake for a 347?
- need advice on h/c/i selections
- Does the oil pump "tube" that goes into the distr shaft ever wear, its kinda loose?
- Rear Seat Delete
- Clutch Questions
- What Next?
- edelbrock rpm II manifold question...
- What is the is the part #for the walbro high pressure fuel pump?
- What is wrong with my car?
- Problem With A/C
- New Meziere 94/95 water pump came in
- Does a stall converter always slip?
- Rev limiter?
- Clutch cable routing
- Two simple rear brake questions
- odometer not working
- Timing??
- Hooking power steering back up.
- Where to Mount Nozzle and lots of other nitrous questions PLEASE HELP
- Tremec install kit compatible with a Fox T5?
- how do get the haze off of my taillights?
- Visible difference in motor oil and power steering fluid?
- My 94 Project
- Tweecer ????
- Verts with LT, do you have the stock x brace on your k member?
- Installing Bumpsteer Kit
- so today, the UPS guy brought.....
- Is my balancer bad?
- vortech v-1 s-trim
- What Ignition Coil's you guys runing "and Vote here"
- New Credit Card
- bullit or mach suspension
- Recommended Tire Pressure ?
- 1 3/4 Longtubes
- gt40p combo question please HELP
- LT header question
- Stall converter on kenne bell?
- 2 quick questions I'm almost running
- M/T Drag Radials
- spark plug help please
- Question about C&L MAF's
- Intake to head gasket question
- Those with Baer 13" rear brakes...help!
- 94 - 95 Chrome Prop Rods ?????
- Speedometer Error
- 4.10's Installed (Finally)
- 10.5s in back?
- NGK spark plugs?
- My NEW H/C/I thread
- problem when taking of fast
- Kirban AFPR On the Way- Easy Install?
- Best paint info
- Removing Driver Side Mirror
- Sos Help
- timing question
- desktop dyno on new motor ?
- FYI: Daytime Running Module for Verts
- Rough idle and ping
- Upper intake problem
- Fuel Pressure and timing
- optima yellow top battery
- Oil separator review...
- Are All Aftermarket Shocks/Struts Created Equal?
- Another stupid cam question.
- Help With Swapping Master Cylinder.
- will i need a new tune?
- Pulling the AC compressor (for cam swap).
- 13.764@101
- Uh-oh, got the p/s pulley on backwards
- Power Steering Flush?
- V6 T5 in a '94-'95 V8 Stang
- Setting lash on rockers.
- Lokar Throttle cable
- 93cobra intake wont work on a 95?!!
- Engine/Trans Setback question...
- damn vacuum tube
- H/c/i 95 Cobra
- Finally got to the strip with my Drs and...
- Another cam swap question.
- me versus non-sti turbo wrx
- what times would i run?
- shwiching to manual?
- Cam swap question.
- Cobra Brake Upgrade Question
- is this for real??
- How to loosen crank bolt?
- heads dyno
- Need help quick (pressure plate bolts)
- Can't get rotors off...help!
- TDC.. here's what I got..
- 95 Gt Vs 2000 Ram Air
- H/C/I question
- have 3500 dollars...347 and HCI suggestions
- Datalog Screen Shot
- T5 Carnage Pics Part II
- This looks like bs take a look
- Planning out my future mods
- I hate my car.
- A different surging RPM problem. No really...
- Just got my Zex Nitrous Kit Today!!!
- Help!! -- Overheating -- Help!!
- 2nd Time NOOB
- Car dying at 4500 rpm!
- Water pump gasket... "Q"
- New #'s-Boost Cooler Works!
- Wish me luck guys, started on my H/C/I project
- Slow To Idle Down???
- surging idle