Build Thread "Rising from Ashes" 94 Cobra build thread
- Thread starter 95steedamustang
- Start date
-
Sponsors (?)
Does the wife ever catch you in the garage with the car "Lovin', Touchin', Squeezin'"?
Ha ha! not to worry. The wife comes out to the garage all time.
Last edited:
earleys94gt
Active Member
YEAHLOH95
Founding Member
Than
Thanks man...Doing quiet a bit of work to the Mach 1 right now, so I'll also try to post some pics of it when done.
Been doing some work to the 04 Mach 1. The car only has 12,000 miles so its pretty clean. The only mods were Bassani longtubes and full exhaust...which I'm sure were not cheap. I am going to be working on this car in phases. This phase is some brake, suspension and detail work on her. I've also got some different wheels going on. But here's where this phase stands. Just about to set it back on the ground for some summer driving.
Here is the start
Some powdercoating
MM Bumpsteer, coilovers, Steeda X2 balljoints and MM sport Bilsteins
Got to add some stuff to the engine bay as well
Should be setting it back down in the next couple of days.
Here is the start
Some powdercoating
MM Bumpsteer, coilovers, Steeda X2 balljoints and MM sport Bilsteins
Got to add some stuff to the engine bay as well
Should be setting it back down in the next couple of days.
YEAHLOH95
Founding Member
Thanks man! should have it down in a few days. Just need to find the time to button a few things up,
Thanks man...after I lost a couple of my Mustangs in a fire...I decided I would go all out and just build a better collection of them. I'm not done yet!
Me too...I remember driving around the Ford lots drooling over an 04 CO Mach 1.
looking good so far. nice choice of suspension parts to get it handling pretty solid. thoughts on a 99-01 cobra bumper? those are the best looking bumpers for the mach 1s
Thanks! I think your right on that one. I will be painting the entire car at some point. The paint is what most consider mint. It has never even seen rain, but its still just factory paint with factory orange peel. I want the glass look and I'm going to paint on all the stripes and such and add some subtle touches.
Not the best pics...I'm still working on the alignment to get it where I want, but this is where I set the ride height.
Its actually the angle. The rear actually sits the same. The first pic was when I was squeezing the new wheels in. I widened the deep dish Mach wheels to 11 inches, so I had to do some work to get them to clear. If I turn the flash on...its red, flash off orange. But that's kinda why I like Competition orange.
YEAHLOH95
Founding Member
i would do a gold pearl over the orange and reclear it that would look awesome and how wide are the tires on rear now ?
