97 Base Brakes To Cobra Brakes

[AGUYNAMEDFRE]

Hey everyone, so as we all know the stock mustang brakes suck. I found someone with a 97 cobra that is parting out his car. His has the full brake kit and was wondering what I take off of it to be able to use those and if I would need anything else to complete this job. I have 17" rims so I believe the rotors should fit. Also anything else you think I could use off of it let me know. Thanks

 

[AGUYNAMEDFRE]

And while I'm here asking this how hard would it be to do a motor and tranny swap to the svt to make the ultimate sleeper. Or at least just the transmission I would like to have a manual. If I wanted all of these parts would it be worth it to just buy the whole car and what would be a reasonable price for these parts.

 

[94GTCoupe]

Front, calipers, caliper brackets, soft lines with banjo bolts, rotors and pads.

Rear, backing plates (bolted to end of axle housing tubes), caliper brackets, rotors and pads.
The rear calipers , dust shields and lines are the same.

 

[AGUYNAMEDFRE]

Front, calipers, caliper brackets, soft lines with banjo bolts, rotors and pads.

Rear, backing plates (bolted to end of axle housing tubes), caliper brackets, rotors and pads.
The rear calipers , dust shields and lines are the same.

Thanks for the information. I have not contacted the guy yet so I don't know what he wants for anything. Any idea what is reasonable for all that?

 

[Mustang5L5]

You'll need to change the master cylinder as well, however, 1997 cobra use hydro boost so it's not compatible with your vacuum boosted brakes.

You'll need an mC from a 94-95 cobra and an adapter kit from max motorsports.

You currently have a 1 1/16" mC. You need a 15/16" mC for the 94-98 Cobra brakes. If you don't change the MC, your pedal will be firmer and you'll leave a lot of performance off the table.

New mC about $100 and adapter kit is about $30ish