anthony05gt

Not sure. Look around and post a want ad in different forum classifieds. Other than that, go to the dealer. I believe it's the engine/tranny portion you'll need. Sorry, I haven't been on this forum for a while.

hey man do you know where i could get the transmission portion of the wiring harness from?

Yes, I sell the wedge tools for $45 shipped. I rent the compressor. You can rent both for 1 week for $50 plus you pay shipping both ways. You can also buy a wedge tool and rent the compressor for $65 you pay shipping both ways.

Anthony - do have that special timing chain locking tool or compressor valve spring?....
Frank

Hey,
I just now checked back on SN and see some of the posts after I posted that I'd switched from Hurst to MGW. I'd hadn't been on SN for quite some time is the reason you couldn't find any posts from me about the shifter change. Also I didn't even think to change me sig until you mentioned it. I really did order and install the MGW shifter. The reason I wouldn't do it again is because at the time of ordering it I already had a Hurst in my car. It just wasn't worth the money for the difference. Comparing the two I would say the MGW is a little better performer but I think the Hurst is a little better looking. I'm not going to take the MGW out. It cost to much and again it is a really nice shifter and I do like it. Sorry to cause a stir.
chubhunter