Stangstroke
Last Activity:
Jun 28, 2013
Joined:
Mar 25, 2011
Messages:
118
Likes Received:
0
Trophy Points:
16
Showcase:
11
Albums:
1
Gender:
Male
Location:
Barrie Onatrio Canada
Occupation:
Manufacturing Consultant

Share This Page

Stangstroke

Member, Male, from Barrie Onatrio Canada

Stangstroke was last seen:
Jun 28, 2013
    1. Stangstroke
      Stangstroke
      hey how are you doing i haven't been on the forum for awhile sorry. Man i like the kenne bell but if i had to do it all over again I'd by myself a 2011 mustang GT and drop on a big KB and put an easy 600RWHP i've spent close to $20K for my setup you have to dig deep in your pocket to make a KB work on an old 5.0 motor. I can give you all the info you need if you still want to do it.
    2. RioRed95GT
      RioRed95GT
      Hi how ya doin? I seen ya had a 2.1 Kenne Bell and i had a few questions for ya. I am getting ready to do the same 2.1 on my 95 GT. I am going to be putting it on a stocky for now. I have plans on doing a 331 with a set of Trick Flow heads hopefully this winter. I plan on doing the custom intercooler also not till winter either? When you did the intercooler did you switch to a fox intake set up? I was going to so i would have a lil bit more room to run the piping from the intercooler to the KB. Also do you think i will be round the 300rwhp mark with 8psi? Any info ya have on this set up would be greatly used! I like the Kenne Bell setup. Its diffrent and I would love to have that nice low end power! =)
    3. Stangstroke
      Stangstroke
      331 Stroker with 2.1 Kenne Bell SC I've built a custom Intercooler
  • Loading...
  • Loading...
  • About

    Gender:
    Male
    Location:
    Barrie Onatrio Canada
    Occupation:
    Manufacturing Consultant
    Car:
    1994 Mustang GT
    My Rides:
    1994 Mustang GT
    1979 Trans-am
    2000 Yukon Denali
    1968 Ford Bronco
    2007 Cadillac DTS

    Signature

    [SIGPIC][/SIGPIC]
    1994 Mustang GT
    331 stroker scat crank and connecting rods with probe pistons 9:1 compression ratio,Kenne Bell 2.6 a and KB boost a pump, custom air to water intercooler, trick flow stage 1 cam, BBK LT headers,BBK catted X pipe,90mm TB,JLT cold air 90mm MAF,42lb Bosch injectors, AFR 185 heads,255lph fuel pump, Astro A5 T5 rebuild, high flow water pump, Fluidyne rad,Auburn 3:31 posi, 505rwhp and 500ftlb's of torque @3000rpm's.:canada:
  • Loading...
  • Loading...