Help!!

[1fastford]

Hey yall, I was in the process of putting underdrive pullies on when i realized i need a impact wrench to get the crank pully off, which of course i don't have, so now i got the stock stuff back together but i don't remember how to rout the belt anyone got a pic??

 

[billyfe390]

Check the sticker on the underside of the hood.

 

[1fastford]

sticker just has vacuum hose routing

 

[downsouthman1]

I don't have a sticker under my hood either. I think there's a diagram in the manual. I don't have pics & can't explain how to route it except start w/ the alternator pulley & go right. Next is water pump I think. Just follow the treads.

 

[decoy562]

Here you go...this is the directions on how to install the underdrive pullies, and has a picture on the bottom of the page, with the belt on there. Hope this helps

Underdrive Pullies Installation

 

[Isaac-1]

Note the belt routing changed at some point on the 4.6 ( I think 99-00 had it one way, and 01+ have it another, but I may be wrong), Also I removed my crank bolt without a impact wrench, I just used a long breaker bar (my impact wrench would not fit in there, I did use the impact wrench on the alternator pulley thoug).

Ike

 

[1fastford]

Thanks for all the help guys. I got the stock stuff back together, I have a friend that works at a dealer, so I'm going to take it over there and we're going to put them on there. I'll make sure i pay attention to the belt this time, lol.