DarkBuddha
Founding Member
Yeah, I've had my eye on those adapters for a while... its good to see they're off backorder again. Actually, I was planning on using 'em if the OEM Machs don't quite fit with the 0.25" spacer. I've mentioned 'em to folks doing the Bullitt wheel swap (since they are the right offset), but almost everyone said that the fact that they're made from CAST rather than BILLET would make them nervous... I say as long as you're not using them in a high performance situation (i.e. high rwhp, or high lateral g) then they're probably just fine for the average cruiser.
I did do a search of ebay for wheel spacers and did find there are plenty of folks selling custom made billet adapters. Sure, they're twice the money of the TDPerfomance ones, but for safety sake it may be worth it...
I did do a search of ebay for wheel spacers and did find there are plenty of folks selling custom made billet adapters. Sure, they're twice the money of the TDPerfomance ones, but for safety sake it may be worth it...
