??? Mach1 Chin spoiler Push Pin Part # ???

[ZIPP0]

Can somebody help me out here?

The part number for the pushpin things that hold up the Mach1 Chin Spoiler?

Your help is appreciated.

 

[ZIPP0]

 

[ZIPP0]

 

[NiteMareGT]

Get you some pp's from AutoZone and drill your holes accordingly.....they'll do just fine. I used self tapping screws in mine for a tighter hold.

 

[btolenti]

http://home.golden.net/~trinity/Mods/mods.htm
from the above site:
Attaching rivets N802781S

Also, a lot of guys around here just drilled the holes and used screws to install....

 

[stangtrooper97]

Can somebody help me out here?

The part number for the pushpin things that hold up the Mach1 Chin Spoiler?

Your help is appreciated.

Paul, stop by the shop and I will get you a bucket full of them.

 

[1low03gt]

I used self tapping screws in mine for a tighter hold.

I did the same!!

 

[ZIPP0]

Thanks for the part number guys!

Paul, stop by the shop and I will get you a bucket full of them.

I plan on stopping by when I manage to get enough money together for Accufab TB & plenum...

 

[Skud]

I bought a bunch of stainless screws, washers, and nuts.. The plastic push pins didn't seem too sturdy to me..

Riley

 

[NiteMareGT]

.........Also, a lot of guys around here just drilled the holes and used screws to install....

You don't need to drill holes using the self tapping screws, they pull themselves through nicely.........

 

[btolenti]

Well, I found it helpful to drill a small hole (sharp 1/16" bit) to make sure when I used the self tapping screw, the screw didn't want to 'walk' and get off center....