march pulleys help

Status
Not open for further replies.

COBRA COUPE

New Member
Sep 9, 2001
27
0
0
florida
I Cannot Get The new Crank Pulley On Is It Supose To Be A Whore To Get To Slide On Or Should It Slide On Easy The Crank Bolt Is Not Long Enough Since The Crank Pulley Wont Slide On Im So ****ing Pissed Hammer Time !!!!!!!
 
  • Sponsors (?)


Well i got the install tool an got it as tight as i could get it an the pulley did not move at all this pulley has to be defective I ended up striping the cranshaft threads what are my options now can they be fixed???? :fuss: :fuss:
 
if you really stripped the threads in the crank youre ****ed. You will have to get a new crank. You could try to rethread the hole but you will then have to find a correct sized bolt to hold it on. It does say in the instructions to boil the pullie setup in hot water before putting them on. Next time read the instructions first.
 
trplblcksnake01 said:
if you really stripped the threads in the crank youre ****ed. You will have to get a new crank. You could try to rethread the hole but you will then have to find a correct sized bolt to hold it on. It does say in the instructions to boil the pullie setup in hot water before putting them on. Next time read the instructions first.

Ok smart ass mine does not say that dont speak unless you know what The fu*k your talking about the pulleys I bought are the march with the S.F.I. dampner no where does it say to boil them it replaces the stock crankshaft like the steeda's bet you feel smart :stupid:
 
Im not the complete dumb ass that stripped out his crank trying to install some stupid pullies. I have the ones that bolt together and in the instructions it tells you to boil them to allow for better fitment. Now dumb **** did you happen to line up the tab with the notch on the ****ing crank if you didnt that would be the cause of this entire problem.
 
Status
Not open for further replies.