ecam and 1.7, around 280-300rwhp?

[bigboredave]

Will I dyno 280-300rwhp with the following combo:

302
cobra intake
gt40p (no work done)
1.7 roller rockers
73mm mas
stock tb
unequal headers
dynomax catback
19lb injectors

car is a t5, with 3.55 gears.

 

[RATM]

I dont know, that would mean that your pushing 320-340 hp at the crank and that seems alot with your set up. I could be wrong though.

Good luck and let us know when you get it dyno'd

 

[nosmatt]

with an f cam, i would guesstimate 282rwhp. with an e .......who knows! i have never seen it work well in anything..........

 

[Matts89LX5.0]

no you will not, maybe 250

 

[DMAN302]

250-260 at best...save your money for a custom or better OTS cam.

 

[jb89coupe]

Depends on what supercharger you go with.

 

[jbj454]

I have an E-Cam and it works great! My car pulls hard versus when it was stock. Check my sig.

 

[bigboredave]

jbj454, what size shot on the 118mph pass?

 

[bigboredave]

Anybody think its a good idea to run 1.7 rockers on just the intake valves and use 1.6's on the exhaust. Should help dynamic compression.

 

[CrazyCobra]

I would think 300rwhp is a little high, I run the E-cam with a little more work done to the engine(see in garage). It runs 107mph in a 3480lbs car this is ~300rwhp(never dyno'd so maybe not). I am swapping the E out, there are way better cams out there OTS or custom.
If you have not purchased this cam I would look around first before you decide.

 

[maverick0716]

Anybody think its a good idea to run 1.7 rockers on just the intake valves and use 1.6's on the exhaust. Should help dynamic compression.

If you were to run only one 1.7 rocker it should be on the exhaust, not the intake. That cam is a single pattern grind and those heads really lack in exhaust flow.

 

[maverick0716]

I would think 300rwhp is a little high, I run the E-cam with a little more work done to the engine(see in garage). It runs 107mph in a 3480lbs car this is ~300rwhp(never dyno'd so maybe not). I am swapping the E out, there are way better cams out there OTS or custom.
If you have not purchased this cam I would look around first before you decide.

I'd say you're quite a bit more than 300 rwhp if you got that mph in a 3480 lbs. car.

 

[Boostin]

I have the following and put down 243std hp and 293std tq:
302
Cobra upper/lower intake
75mm holley tb
77mm pro-m mass air meter and intake
1.7rr
30lb injectors
o/r x with flowmasters dumped
t-5 with 3:73 gears

 

[just4bob50]

who knows i dyno'ed at 250 hp and 290 tq to the wheels with stock heads and cam. My vert runs 13.50s to back up the numbers