Oil Sensor Bung Plug Size?

[91lxvert]

Oil Level Sensor Bung Plug Size?

Does anyone know what size hole and thread that the oil level senor is on our oil pans. I dont want to put the sensor back in and it should only be about 3 bucks for the threaded plug.

Also where might i find this threaded plug?
thanks

 

[91lxvert]

ttt

 

[mustangjoe87]

plumbing supply store

 

[bryanrevans]

ok Brandon got it from kragens its the ones on end of ile fits front oil pan plug also.use rtv since youll leave it alone.Sorry it took soo long I just got into Mass.rain everyday miss Cali for some reason.humid as hell cost of livin is horrible!!!!!!

 

[bryanrevans]

by the way that taurus fan hooked up on low speed wire cooled at 195 whole trip.it was like 110 in Az.
the faster I drove the less fan kicked on!!!!

 

[The Shape]

I just took my oil level sensor to the hardware store and found a bolt the same thread. Put a washer on it with some high temp RTV And it worked great.

 

[LoudToy958]

I just took my oil level sensor to the hardware store and found a bolt the same thread. Put a washer on it with some high temp RTV And it worked great.

I did the same, but I had the bolt machined and used it for my oil temp sensor. Worked out great. Just an idea......

 

[mustang-a-holic]

plumbing supply store

I tried that. I went into the plumbing store and told the guy, "If I show you my bung hole could you show me a bung plug that fits?"

He punched me.

 

[HISSIN50]

I tried that. I went into the plumbing store and told the guy, "If I show you my bung hole could you show me a bung plug that fits?"

He punched me.

Seldom does someone post something worthy of a CT in their very first post here.

 

[5.02GO]

Gentleman i believe its 1/8 NPT.


National Pipe Thread.......



Edited to say................


"i read the question wrong". I was thinking about the oil pressure sensor. Not the oil level sensor.

 

[91lxvert]

bump, still lookin, i dont have an extra pan or even 1 sensor to take

 

[bryanrevans]

you saw my oil pan I used the same bolt that goes on the front drain hump.I handed you the pan and said"look it fit perfectly'"remember ford red oil-pan??????