V_Eight I can understand why you would quit, your brilliance can hardly be contained. Anyway, AmBo, go to Circuit City and ask for part number MET 805511. This is a wiring harness that plugs into your factory harness. When you decide on which headunit you want, Circuit City also carries the part that goes directly into the headunit, so you don't have to cut and splice. However, you are going to need to cut the black, rectangular part of the MET 805511 about half way down. Tape the wires still on the harness together, and strip the eight wires that lead into the black connector itself. Get a cheap set of RCAs and cut them in half and strip the coating off of them, be carefull because each wire contains two seperate strands of wire. Just connect the eight wires from the black plug to the eight wires from the RCAs. All you do then is hook them into the Front and Rear outputs on the back of your headunit. This makes them a low level signal and not a high level, and you don't get the amplification from the aftermarket headunit to your factory amps. You will not need any type of mounting bracket for the 99-00 years. To do this you will need three sets of preouts. V_Eight you're an idiot.