I know I have not been on the boards much latley, but I'd figure i'd let you guys know where I'm at with my second turbo mustang project..The motor I'm using was out of an '87 TurboCoupe, when I got it the turbo went bad on the previous owner and shot crap all thru the oil pan and spun a few bearings. so I ripped apart the whole motor, honed the cylinder walls, added 'cross-hatching', bought all new 'Clevite 77' bearings, and used another crank. I have the crankshaft installed right now, I'm looking to add ARP rod bolts and start installing the rods and pistons with new 'Perfect Circle' rings. Meanwhile I'm porting the stock head and install a roller cam. But while I do all this work I'm still in need of some parts...
-Starter Plate
-Flywheel Bolts
-VAM Harness
-K&N Cone Filter
-Water Pump
-Metal / Rubber Valve Cover Gasket
-Kurban Adjustable Fuel Presure Regulator
-SPEC Stage III Clutch Set
-Clutch Fork
-Maximum Motorsports Clutch Cable, Firewall Adjuster, Quadrant Kit
-2.3 Liter Bellhousing
-Speed Sensor
-Lower (Floor) Shifter Boot
-Optima Battery
-VAM Intake Tube (To Turbo)
-Belts & Tune-Up Parts
-UPR Blue Thunder/Steeda Tri-Ax Shifter
After I have the car up and running, I'm going to spray it Ultra Red I have it layed out on the rear bumper already and it looks great.
-Starter Plate
-Flywheel Bolts
-VAM Harness
-K&N Cone Filter
-Water Pump
-Metal / Rubber Valve Cover Gasket
-Kurban Adjustable Fuel Presure Regulator
-SPEC Stage III Clutch Set
-Clutch Fork
-Maximum Motorsports Clutch Cable, Firewall Adjuster, Quadrant Kit
-2.3 Liter Bellhousing
-Speed Sensor
-Lower (Floor) Shifter Boot
-Optima Battery
-VAM Intake Tube (To Turbo)
-Belts & Tune-Up Parts
-UPR Blue Thunder/Steeda Tri-Ax Shifter
After I have the car up and running, I'm going to spray it Ultra Red I have it layed out on the rear bumper already and it looks great.