Who has SN95 spindles on there FOX?

[Gearjamer]

I've got a question for those of you who have done this convertion. I Just put a set of 95 spindles on my 85 GT. I have the stock control arms ,K-member, MM caster camber plates, and Cobra brakes. Now I can't get negative camber in my alignment. Anyone else have this issue? The alingment shop said my chassis is tweaked which is possible. The car had been in an accident before I got it.

Thanks,
Bill

 

[281pony]

no problems with mine.

 

[stangman393]

No problems here either but to correct it you can elongate the strut mounting holes to the spindles. Take the 2 upper holes and elongate them inboard. When you go to tighten them back up make sure you are holding the spindle in the negative most position.

 

[ddonaca351]

Mine was ok too... might be worth a couple hun to have a frame shop pull it out square.

DD

 

[stangman393]

Possibly just get a new k member might fix the problem.

 

[Gearjamer]

I'm going to be looking into having the frame checked and fixed if nessassary. My final plan is to install a MM k-member and Evolution Motorsports Tri-link with watts link out back. I'll have some extra parts left over if anybody is interested.
Global West track link, caster camber plates, front control arms with Del-a-lum bushings, and springs.

-Bill

 

[charged9250]

No problems with mine.

 

[ddonaca351]

I'm going to be looking into having the frame checked and fixed if nessassary. My final plan is to install a MM k-member and Evolution Motorsports Tri-link with watts link out back. I'll have some extra parts left over if anybody is interested.
Global West track link, caster camber plates, front control arms with Del-a-lum bushings, and springs.

-Bill

Ya know if youre already going with MM up front, they make a pretty damn good 3 link (torque arm) for the rear... just a thought.

DD