Finally started working on my center console
- Thread starter iskwezm
- Start date
-
Sponsors (?)
Pbum5
Member
Sweet Ride!
Have to point one thing out.
It's obvious that you have put in a lot of time and money in you car.
Why do you still have a single bowl MC for your brakes?
Get yourself a dual bowl Master Cylinder man!!
I'll also take one of those center consoles.
Have to point one thing out.
It's obvious that you have put in a lot of time and money in you car.
Why do you still have a single bowl MC for your brakes?
Get yourself a dual bowl Master Cylinder man!!
I'll also take one of those center consoles.
Honestly, i never had a problem, but within the last few months, i have realized a lot of people have switched and now I know the reasons for it.So I learned something,just been lazyPbum5 said:
Swede958
Founding Member
Awesome job man... and great car too
Out of curiosity... what kind of material did you use to cover the console with?
Out of curiosity... what kind of material did you use to cover the console with?
krash kendall
Active Member
Looks inspirational!
Do you have a table router? You could probably make some trim rings for those cup holders with some black PVC pipe.
Do you have a table router? You could probably make some trim rings for those cup holders with some black PVC pipe.
i did buy some PVC,it either too big or too small,but i have some speaker ports that i need to cut down.The holders are big enough for a Big Gulpkrash kendall said:
SitDown
Founding Member
very nice! i havnt really been a fan of any of the consoles ive seen, until today...put me on the list too 
Pbum5
Member
iskwezm said:Honestly, i never had a problem, but within the last few months, i have realized a lot of people have switched and now I know the reasons for it.So I learned something,just been lazy
that's cool. just wanted to mention it to ya..
Great Job on your console!
If you have any boat dealerships nearby you might check them out for cup holders. My buddy bought some for his boat at one of the local dealerships that sold replacement parts and accessories. If you've ever been on a ski boat you've probably seen them. They're basically a black plastic cup with a rim that sets on the lip of your hole. They were only two or three dollars a piece.
Tim65GT
Active Member
Here's where I got my cupholders:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=35749&item=6224687225
they are meant for poker tables.
I started my console before the holidays, and I'm almost done.
I'll post some pics later.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=35749&item=6224687225
they are meant for poker tables.
I started my console before the holidays, and I'm almost done.
I'll post some pics later.
the hardest part is making the framework,stretch fleec over it,resin it, start adding mat for strength if needed, then bondo to smooth it out then sand ,sand,sand and sand some more66moneypit said:
