White Face Guages

[Mustang5L5]

Yeah, they look identical. I did notice the off center oil and water temp gauge but to be honest it's not bad enough to bother me. I don't even look at those gauges anyway, just tach and speedo.

I think the new ones on ebay have 4 separate sections now rather than 1 solid sheet.

 

[y2kstang grl]

I have the speedhut gauges also. They were a snap to install just be patient when working the needle through the hole. It took me about 5 minutes. The hardest part is getting the plastic piece off to get into the gauges.

 

[BlackenedSVT]

Anyone have a problem installing the needles again after you put the white face guages on? I got some $25 e-bay ones for my last 98GT and they fit and looked perfect...but the RPM needle would always "hang" a little bit when i revved it, and took a tiny bit of time to settle back down...almost like it was sticking

very annoying


anyone else have problems with "sticking" needles after they instlal the new guages? I thought it was becasue i put them on too hard, but even when i BARELY snapped them on, they still hung. I traded the car in shortly after anyway so i didn't care....but im cautious now to buy another aftermarket set...

 

[loosescrew79]

Mine were sticking but it was only because I pushed them in to far. They work great now. Think I'm going to remove them and cut the warning light section out after seeing the pics of everyone elses

 

[mrshl13]

I have the same problem but I worry about cutting any off because it looks like the bottom piece is required to complete the circuit for the "glow" lighting.

 

[WOT]

I bought mine a couple of years back from SR Motorsports on Ebay. They look grerat and are indiglo too. Had mine for over 4 years now, not a problem and look like factory gauges too.

 

[2002GreyGT]

Anyone got pics of the Speedhuts installed?

Also, I did not see an option on their web site to do White back with black lettering while doing reserve glow's. They only had White backs with Dark Blue as the closest.

~K