Anyone using charge motion plates w/ supercharger?

[bigcat]

was wondering if anyone was using this with their blower? seems like it would boost peak power up a bit....i know the new motor is an unknown right now, but someone has to be using these with a blower to get more power....who is it?

 

[Nolyaw]

was wondering if anyone was using this with their blower? seems like it would boost peak power up a bit....i know the new motor is an unknown right now, but someone has to be using these with a blower to get more power....who is it?

Dont need them with a procharger. My car is at a peak of 469.88 HP to the ground. Maybe a Vortech guy could use 'em....

 

[300bhp/ton]

Dont need them with a procharger. My car is at a peak of 469.88 HP to the ground. Maybe a Vortech guy could use 'em....

where you get that 'Dumn ass comments R us!'

 

[bigcat]

Dont need them with a procharger. My car is at a peak of 469.88 HP to the ground. Maybe a Vortech guy could use 'em....

of course you dont NEED them, but they probably help out.

 

[1bad05]

i think that on a forced induced engine your getting plenty of flow from a performance point of view but i don't like the fact that the computer open and closes them for you (like between shifts for example). there strickly for emissions and don't have any buisness on a performance engine. i will be removing mine very soon.

 

[WSD42]

I have a new in the box set of the Steeda CMCP's that I am not going to install on my 05' GT. I am going with the Whipple SC soon, so they will not be used. E-mail me at: [email protected]

$200.00 + shipping. I paid the same when I bought them.

 

[anthony05gt]

Whipple..............sweeeeet!!