fog light change

loudog_jon

Founding Member
Mar 28, 2001
195
0
17
Florida
Hi all, I searched the forums and all over the internet today trying to figure out my foglights. I added a Cobra front bumper to my GT with foglights, but now i do not have any power to the lights. the interior switch doesn't even have power to its light. I checked the fuse and the two relays, but they are ok. I believe the wiring is fine, I only connected them to the new lights. Neither of the lights work, and there is no juice to the switch. Any wiring gurus out there that can help?

thanks.
 
  • Sponsors (?)


What year Cobra bumper: 99-01' or 03-04? I have a 99-01' Cobra bumper and it just hooked right up no problem, same as the GT connections. But I know the wiring is different for the 03-04' bumpers and you have to do some splicing I believe.
 
Sorry for the delay in reply, and i appreciat the help.

Blinkstang: it is an 99-01 bumper

BlueRuckus: thank you for the idea, but different year

n0v8or: i get no power at all. the little orange light on the switch is never on.

Thanks again for the replies, any ideas?
 
i've swapped all fuses known with ones that are in working condition and back, no change. does anyone have the wiring diagram to show how the power gets routed? the may be a short somewhere. thanks
 
ok, just installed the fog light switch, the light works on the switch (power to the switch) but still nothing for the fogs. i swapped the fuses with known good fuses and nothing. any ideas? how about the bulbs themselves, what model number bulds should i have? thanks for the help
 
yes, i have checked all the fuses in the engine compartment, is there a fog light fuse inside the car? again, the switch has been replaced, and now has power going to the switch. thanks again.
 
Are you getting power OUT of the switch to the light plugs? Check with a meter and see. The use of a meter will save you chasing the unknown only to still have questions. I always check for power at the light, then work back from there. Any fuse you would have in the system would most likely be before the switch. Power at the switch, then any relays and then the lights.
 
I agree, get a test light or a mutlimeter and check the power at the sockets when you have them on, have you tried pluging a stock GT foglight setup back into the connectors to see if they power up ?