intake setup

[pacesco]

ok, here's what I have.
347cui
scat forged steel crank
h-beam rods
balanced
RHS cyclone 200/64 heads
Comp cam duration @ .5 lift, intake 224 exhaust 236
10:1 compresion ratio (should be able to run pump gas)
AODE trans
2800rpm stall converter
125hp wet zex nitrous kit to install

here's my question...
what intake set up should i run? i was looking at the BBK SSI set up??? also what size injectors, fuel pump, and should i change the fuel rails and pressure regulator? should i change the computer, what is the best one to go with?

any help on this would be great...

brian

 

[95strokerPSU]

Edelbrock RPM II and 42lbers.

 

[pacesco]

what computer are you running?

 

[pacesco]

i have a gt40 intake that i was thinking about sending out to extrude hone and matched to my intake ports on the heads.. any thoughts?

 

[RIO5.0]

Your not gonna Extrude Hone a GT40 a whole bunch...The tubing is thin stuff as it is...Something tells me the GT40 is not the best choice for your set-up...and the BBK is kinda so so power wise to the normal 5.0 intakes..Both look nice but they're not the best performers..

I would think the stock ECC and an SC would do just fine...depends on your budget??

 

[bimmertech]

Edelbrock RPM II and 42lbers.

if you decide to man up on the cam/converter then do a vic jr.