Complete shifter!!!

[SpartaPerformance]

I'm looking for a complete shifter with positive shift stops, not considering hurst I prefer to use the stock knob, so does anybody have any ideas?? Pro 5.0 or B&M ripper (if available). Also I hear the complete shifter is a mother to install, have to remove console and drive shaft and go from underneath??? Appreciate any suggestions and advise.!!

 

[subzero05]

PM send to you. Actually the shifters on these cars isn't that big a deal to install.

 

[D-06]

I suggest the MGW for what your looking for

They are not real hard to install, I did mine with a firend in about an hour

 

[saxd]

MGW by far. Easy install, even on ramps. You don't need to removed the driveshaft.

 

[anthony05gt]

I've had a Triax (same as Pro50).....didn't cut it at all. Installed the MGW kit and couldn't be happier. Until the MGW came along recently the Pro50 and Steeda triax were about as good as it got. If you really want a bad azz shifter, don't pass up the MGW...it's the bomb.

 

[SpartaPerformance]

I'm convinced after going to the MGW website. Did you guys also purchase the extra shift blocker piece???

 

[GOLDENPONY]

MGW Shifter

MGW - You won't be sorry. Skip the stop kit. Not needed and possibly can hurt tranny.

 

[gt06]

I installed a Hurst in my car, not exactly thrilled with it......Anyway, the install itself is pretty easy.

 

[AznStanger3v]

on my car, i put the B&M on it.
on my dads, he put the Saleen short throw adapter.

they feel the same, except his shifts are smoother, and the block only cost 40 bucks or so.... that damn hindsight and it being 20/20

 

[Calipony]

Hey guys, long time Hurst fan here.... That was until I put the Roush in my car. I'm never going back. The Roush is a few bucks more, but this is the real deal. Shortest shifts and I don't get blocked out of any gears. I couldn't be happier.

 

[anticubicle]

I'm pretty much sold on the MGW as well. (It's a toss up between an X-Pipe and the MGW for my next mod)

About the install, is it necessary to put it up on ramps?

 

[anthony05gt]

Yes

 

[Hoboattacker]

Ramps or jackstands unless you're a really skinny dude. Even I had to put it on jackstands and I weigh 150~ and am 6' tall.

 

[SinCityVogel]

I have the Steeda and it ratles, its hard to get in reverse, and it doesnt seal to the boot. I HATE IT.
I want the MGW

 

[homebrewer]

I don't have a shifter yet, but it is close to the top of my list for the first mods.....

First off, I am the first to say that form follows function. As long as it works I don't care what it looks like. That being said, am I the only one that would LOVE to see a shifter of MGW quality with the looks of the Hurst? Personally, for me, that would be the ultimate combination.....

 

[kkdoughboy]

X-pipe vs. MGW Shifter. That might be the toughest decision you even make. I'll let that one up to you. I would get both and install them at the same time. Both installs are very easy with the proper tools.