Longtubes??

[MustangOwner]

Nice coating you have there . Sorry, thanks for the picture.
I do have problems even with shorties, and bbk x-pipe, not to hit on the wall of my garage with a minor lowering. Now i can see that L/T wont be worth the hp for me with that ground clearance.

Oh no no, this is not my car! I'd rip those suns of bi tches off as fast as i could if it were mine! Thats Bassani for yah though! Over priced Shi t! $899.99 for those, what a bunch of chit

 

[bloopbloob]

those hang extremely low! my bbks don't hang lower than anything else under the car. don't let that picture make you think thats how all lts are going to sit!!

 

[stykthyn]

those hang extremely low! my bbks don't hang lower than anything else under the car. don't let that picture make you think thats how all lts are going to sit!!

+1 on that one. dont let one pic of a piss poor install turn you away. out of all the cars and trucks I have owned I have never been disappointed with the results from adding LT's. they have been around forever b/c they work. period.
spend the time and money to get them installed correctly the first time and crap like whats in that pic wont be a problem for you.

 

[1991vert]

Unless you have a visual check......

usually they jack it up and check ball joints. dunno what else they pay attention to while they're down there

 

[zx9rrick]

Pic with bbk longtubes

 

[stykthyn]

that is one clean suspension! does it see a lot of street miles?

 

[Thomas302]

How do the bbk long tubes headers fit with a lakewood safety bell?

 

[FoxRod87]

had bbks on an 87 and it was pretty simple. Just had to loosen the passenger side motor mount and jack up that side to get it in. and the driver side went right in with no problems.

 

[cevtv]

usually they jack it up and check ball joints. dunno what else they pay attention to while they're down there

Yeah - that's part of the safety check, not the emissions visual.

 

[MrXCESSIVESPEED]

How do the bbk long tubes headers fit with a lakewood safety bell?

usually require you to clearance the scattershield flange slightly with nearly any long tube header. My Kooks didnt need any clearancing, but they are the only ones Ive used that were that way.

 

[TrickFlowd]

The only thing that sucks about LT's are the o2 sensor extentions, because there is no where to tie them up. But I heard that Advance Auto sells o2 sensors with longer wiring?

 

[cenok is family]

The only thing that sucks about LT's are the o2 sensor extentions, because there is no where to tie them up. But I heard that Advance Auto sells o2 sensors with longer wiring?

yeah i know! my o2's hang down and it pisses me off. if you're within a 30' radius of my car you can't see them because my car is low, but anywhere outside of that, it looks like crap with chit hanging down under my car. they're definitely worth it though. just not the crappy hedman's i have...

 

[Grn92LX]

How do the bbk long tubes headers fit with a lakewood safety bell?

Wont fit with a lakewood, you'll need to cut the bell. They will fit with a mcleod bell.

 

[MrXCESSIVESPEED]

The only thing that sucks about LT's are the o2 sensor extentions, because there is no where to tie them up. But I heard that Advance Auto sells o2 sensors with longer wiring?

Advance and auto zone both sell 02s with a longer harness. Really only the LH side needs it. I dont use harness extensions at all and I have plenty of length in the stock harness....and my long tubes may be a little longer than BBKs

View attachment 347871

 

[cenok is family]

Advance and auto zone both sell 02s with a longer harness. Really only the LH side needs it. I dont use harness extensions at all and I have plenty of length in the stock harness....and my long tubes may be a little longer than BBKs

View attachment 347869

yeah i didn't have to use extensions either. if anything, i wish my o2 harness' were shorter to take up some of the slack.

 

[TrickFlowd]

Advance and auto zone both sell 02s with a longer harness. Really only the LH side needs it. I dont use harness extensions at all and I have plenty of length in the stock harness....and my long tubes may be a little longer than BBKs

View attachment 347867

Man your car looks good!!!! What suspension? I love the way it sits. I want DETAILS!!! haha.

I actually bought my car and it had extentions, I guess I know what I'm going to do this weekend. Take those faulkers off!!!

 

[MrXCESSIVESPEED]

Man your car looks good!!!! What suspension? I love the way it sits. I want DETAILS!!! haha.

I actually bought my car and it had extentions, I guess I know what I'm going to do this weekend. Take those faulkers off!!!

Thanks man, I appreciate it. I'lll shoot ya a PM so I dont hijack the thread.