5.0Droptop
...all those nights we shared, and you're a dude??
Special Agent Mukity-Muck Whats in Charge Round Here
well this time i really f&*%@#() up
- Thread starter ryan218
- Start date
-
Sponsors (?)
Snake1
Founding Member
try a cold chisel and a hammer to get the nut off if you don't have a hot wrench.
Another trick is to find a co2 fire extinguisher and spray the nut and bolt.The cold from the co2 shrinks the manifold bolt and you can pretty near take the nut off with your fingers but don't,co2 is very cold.
Another trick is to find a co2 fire extinguisher and spray the nut and bolt.The cold from the co2 shrinks the manifold bolt and you can pretty near take the nut off with your fingers but don't,co2 is very cold.
Snake1
Founding Member
if you're referring to my post,don't laugh sonny,it works and was being done while you were stil in diapers.
'Course first you have to know what CO2 is.
'Course first you have to know what CO2 is.
blackened88lx
Active Member
with my finger
Is that cause it's bigger than your... nevermind
While all of these methods seem great, I like the "use the right ****ing size to begin with method", it seems to work well. If you do somehow end up stripping something, hammering on a 12 point just about always works if you do it right.
How to split a nut...
Get out your 1/8" drill bit and drill two holes side by side on the flat part of the nut in line with the stud. If you are careful, you will drill the nut and never damage the stud.
Next use a cold chisel to split the nut at the flat where you drilled the two holes.
Get out your 1/8" drill bit and drill two holes side by side on the flat part of the nut in line with the stud. If you are careful, you will drill the nut and never damage the stud.
Next use a cold chisel to split the nut at the flat where you drilled the two holes.
Attachments
bloopbloob
Member
How to split a nut...
Get out your 1/8" drill bit and drill two holes side by side on the flat part of the nut in line with the stud. If you are careful, you will drill the nut and never damage the stud.
Next use a cold chisel to split the nut at the flat where you drilled the two holes.
excellent info! now do you have a diagram of how to bust a nut?????
5.0Droptop
...all those nights we shared, and you're a dude??
Special Agent Mukity-Muck Whats in Charge Round Here
The derailer on your ten speed bike misses a gear while pedaling up a steep hill and the chain falls off...
blackened88lx
Active Member
5.0Droptop
...all those nights we shared, and you're a dude??
Special Agent Mukity-Muck Whats in Charge Round Here
bloopbloob
Member
HE FIRED IT OFF AND HE NEVER MISSED A BEAT!
jrichker is just a computer program that spits out the answer to everyone's problems! everybody knows that by now!
1991GreeNLX
New Member
i've done it many time's not strip my header bolt but what you can do is buy some steal wool find a bolt that fit's it best stuff the socket with steal wool and it should grab try that don't saw it off then you'll really be fcked 
riceslayer302
Banned
ive cut a flat edge onto a round bolt a few times and he's right it does work well, even if you just do two edges and get those vice grips on there better
Similar threads
