Need pictures of stock 99-04 4.6L 2v engine

[Kurgan]

In particular, looking for pictures of the vacuum line routing and the EGR valve/electronics setup. Close-ups would be great! I want to make sure I've got the vacuum lines all run correctly.

I tried searching my factory service manual CD for a vacuum line diagram, but couldn't find one.

I know a few of you have to still have the stock intake/vacuum/egr setup out there and happen to have a digital camera. (Stock? What's that?!)

 

[SonicStangGT]

This is all I got, my motor is out of car right know, hope it helps.
View attachment 313369

 

[sicK96GT]

why are you rebuilding that engine... would it have anything to do with the 125 shot

 

[lover]

why are you rebuilding that engine... would it have anything to do with the 125 shot

Yeah, with your mods and stock internals, I wouldn't put more than a 75 shot on those stock pistons. A 100 shot max with a good tune. But if you're rebuilding for other reasons, you have a freak stock block...

 

[SVT32VDOHC]

Not a close up, and it's in my fox body, but this might help...stock with just a CAI.

 

[SonicStangGT]

Not the 125 shot, I am installing the flat top pistons with flycuts for the 278's because I had ptv, had the heads ported and a valve job. Also installing long tubes and new h-pipe,cant wait to hear it run again. I put the nitrous on with 6,000 miles and now have 34,000 and the internals look great. Belive it or not. Yeah I put it through hell and it never breaks, I,ve had the 125 shot for about year and a half. I'am really going to test it with a 150 shot. Still going to be like a stock bottom because I used stock flat top cobra pistons. I did'nt want to spend alot of money on this build because in a year or two I'am going to a turbo setup. So I going to beef it up then. I'am just trying to build a cheap N/A motor to get close to 290-300 rwhp and about 425 to 450 with the spray.

 

[Kurgan]

This is all I got, my motor is out of car right know, hope it helps.
http://i252.photobucket.com/albums/hh11/sunnyredhead1/HPIM1182.jpg

Thanks. That picture helps a bit.

Can someone confirm this diagram I made is correct?

The heavy black lines are rubber hoses. The red/green lines are the smaller plastic vacuum lines.

 

[Kurgan]

Not a close up, and it's in my fox body, but this might help...stock with just a CAI.

http://i184.photobucket.com/albums/x258/svt32vdohc/91 notch/DSC04563.jpg

I can't really see the vacuum lines very well in your picture, but thanks anyway

 

[Stark77]

awesome diagram Kurgan - very helpful!

 

[Kurgan]

awesome diagram Kurgan - very helpful!

Thanks, but I don't know yet that it's right! I need someone to verify that my diagram matches their vacuum routing on their car.

I still have my EGR disconnected. Last I tried to reconnect it, I had horrible problems with the engine running. So I had to plug up those vacuum lines because I don't think I had it all hooked up right.