08 V6 Exhaust????

[ETN V6]

I want to make my V6 sound more like the factory V8. Exhaust suggestions?

 

[NastyStang113]

Put GT mufflers on it. Buy the left side over the axle pipe and hangers. Cut the rear bumper. Chop up a factory GT H pipe to fit. Justin at VMP Tuning sells the GT mufflers.

 

[ETN V6]

GTexaust

Will these GT exaust fit for V6? Where could I get these?

 

[NastyStang113]

Yes it fits.

VMP Tuning - Buy Ford SCT & GM Custom Handheld Flash Tuners Performance Economy Towing: 05+ GT Takeoff Mufflers pair for 05+ V6 Mustang

 

[dhthomas40]

I installed a GT take-off on my V6 that I purchased on-line for $50. (GT owners install aftermarket exhausts and sell the take-offs) I had a local muffler shop do the install. They had to bend the mounts slightly to center the tip in the fascia opening. Also the tip may stick out more than desired. I cut mine back about one inch and installed a GT stainless tip. Overall, it's great! (improved sound and less restrictive).

 

[The Fang]

I hear frpp now has a setup for the 6r, wonder what it sounds like.

 

[NastyStang113]

The FRPP kit is pretty nice, the mufflers sound pretty good but they aren't much different than GT mufflers. So, essentially you're paying a lot of money because it's a kit.

I installed a GT take-off on my V6 that I purchased on-line for $50. (GT owners install aftermarket exhausts and sell the take-offs) I had a local muffler shop do the install. They had to bend the mounts slightly to center the tip in the fascia opening. Also the tip may stick out more than desired. I cut mine back about one inch and installed a GT stainless tip. Overall, it's great! (improved sound and less restrictive).

They should of just loosened up the mid pipe and twisted the piping. There's no reason to bend the hangers. As long as it looks good though.

 

[dhthomas40]

Thanks for the tip. Overall, I'm very satisfied.