I purchased a replacement boot on Ebay from Seller "nedj2000'. I had an automatic plastic bezel that I used since it was in much better condition than the stick shift one that came on the car. I took the boot and used fast setting epoxy to attach it to the plastic. Clean the plastic with alcohol in the places it attaches. I just had to cut out a small section for where the cigarette lighter was at. The top of the new boot did not have the metal grommet but was sewn small enough to just fit over the stick. I used a washer and a nut the same thread pitch of the stick to hold the boot down. I then attached my Hammer Lever shifter handle.