CHE K-Member Brace with Torque Limiters

[COBESGT]

This question goes out to all who have the CHE K-Member Brace with Torque Limiters. I'm pretty sure that I'm going to purchase one, but I wanted to know if this going to add much vibration/noise to the car, seat area, shifter? I'd like to hear your pros/cons.

Thanks!

 

[DarkFireGT]

Little to none. The only difference I really noticed (besides better shifts) is the whole car torques when you give it a rev in neutral. But I didn't really notice any additional noise or vibration.

 

[rugedraw]

I noticed no NVH. +1 about the car torquing over when you rev it. Feels kinda niiiiice.......

 

[autumn_again]

i noticed some noise. i went with the competition ends. and honestly, its no more noise then the car made factory. i have factory exhaust and it is louder then the noise. you have to really look for it to hear it.

 

[69mach1-409]

Next to no noise, but alittle more vibration on cold starts. Nothing bad though.

The car feels tighter and the shifts are alot better.

 

[COBESGT]

Thanks for all of the positive replies, I think I'm going to put in my order today!

 

[cycosarge]

I noticed no NVH. +1 about the car torquing over when you rev it. Feels kinda niiiiice.......

Hey man, about your hood, I see it's ram air, but does the rear of the hood have an opening to let air out at the windshield or is it closed off? I am looking for a hood that will allow airflow to cross the top of the engine and come out the back.