did you run the bosch platinum +4's? i hear they add upwards of 20hp A PIECE
autolites gapped to .054 FTW, i mean... if i had a mustang that's what i'd use...
The factory gaped them, and recommends .054
Nope, stock motor craft. Now put down the "Rice HP Guide", and walk away from the table....
Hmmm. So should you run a factory gap with HCI?
you could gap them a little smaller but the factory recommended gap works fine. anywhere between .048-.054 works. i think i have mine at .049 or somewhere around there.
Oh ok... I thought someone told me to gap them at like .045, but if thats not enough I will pull em back out a regap them...
you should be fine with that. is your car pinging or anything?
Not that I noticed, car runs fine, I was just curious. I just through in new plugs, wires, cap & rotor, 255lph pump, 24lb injectors, & 76mm C&L maf. Fuel pressure is set at 38lbs, but can't remember the timing, but I know it wasn't too much, maybe 14 degrees give or take?
Autolite 23s gapped to .35 ftw.