now we are finally getting somewhere.
that is a totally cool setup you have now!
Thanks alot Blackvert the car's a ton of fun to drive now!!!!
I'll see about putting a video on youtube tomorrow of the car.
331 stroker with 2.1 KB has anyone fabed IC
- Thread starter Stangstroke
- Start date
Thanks alot Blackvert the car's a ton of fun to drive now!!!!
I'll see about putting a video on youtube tomorrow of the car.-
Sponsors (?)
Yes your right but the elbow was opened up but still not enough airflow we'll be taking care of that soon.
The last dyno pull showed 383rwhp and 481ftlb's of torque not bad we'll see what we get after moding the intake here's a short video of my car.
http://www.youtube.com/watch?v=neT4W-X27GE
http://www.youtube.com/watch?v=neT4W-X27GE
Hey guys haven't been on the site for awhile. I went to Fontana auto club speedway and ran the car in the 1/4 it did alright i ran a 12.47 at 109 mph on street tires.
What did you get for final numbers after ya messed with the inlet side? I just did a KB on my stock motor for now. I am already planing to do a 331 just got to come up with the cash. I am planning to fab up a A2A for mine also. I am going to switch to the fox inlet and run my return pipe from the intercooler up the pass. side and in where the bypass is. Just like the guy did with the 92 fox i seen on here!
We haven't started the inlet side of the blower yet but should be complete before Christmas this year we are also going to change out the blower to a 2.6L blower from the 2.1L we think our numbers are going to come in somewhere around 550 RWHP with about 600 FTLB's of torque i should be about 11.5 in the quarter on street tires. You'll like the A2A intercooler it didn't make much HP but lots more torque the stuff you feel in the seat of your pants when you push the Go pedal.
You'll pick up a ton of torque with the A2A and won't need a meth system at all, i picked up 100ftlbs of torque by only adding the A2A.
Kenne Bell Blower whine at the Queen Mary car show fast forward the video to about 12:37 and you'll see my car leaving the show.
15th mustang car show - YouTube
15th mustang car show - YouTube
Well back at shop the car is fabricating a new inlet side to the blower, new 90mm throttle body and getting rid of the flowzilla intake and fabricating a custom aluminum inlet. I'm shooting for about 480 to 500 RWHP and almost 600 ftlb's of torque we will see what i end up with in about a week to a week and half. The car then goes to the body shop for a complete repaint can't wait untill it's all done, i'll post the numbers as soon as i have them.
If i could get all my money back i'd buy a new mustang GT and throw a big KB on it and have 600rwhp and be done with it!!!!! I understand i had multiple options for my car when i started this but there's a certain cool factor to lifting the hood and seeing all the very trick stuff under my hood but does that out weigh the cost definately not but it is what it is now.
