Preparing to install Taurus el fan

[mhjo]

I just got hold of a used Taurus fan that I wish to install for replacement for my mechanical clutch fan. Two things I am looking to improve, 1. less fan drag, 2. better cooling in traffic jams.

Do I need a stronger dynamo?


. Thanks

 

[mhjo]

Anyone?

 

[palerider94]

I give whats a dynamo?

 

[horseballz]

I assume dynamo=alternator and yes you do need a bigger one, along with a bigger/heavier wire from it to the battery side of the solenoid. You also need to make sure the fan gets its power through a heavy relay fed directly from the battery.
Gene

 

[Federico Garza]

3G alternator upgrade is a must for this conversion

 

[iskwezm]

I have a 100 A alternator that also powers the Taurus fan,wtaer pump,fuel pump,MSD, and A LOT of car audio and its fine

 

[mhjo]

I have ordered a 100 amp. Anyone have a good write up for Taurus fan installation?

I have this fan controller:

http://www.summitracing.com/parts/PRF-30141

 

[rbohm]

I have ordered a 100 amp. Anyone have a good write up for Taurus fan installation?

I have this fan controller:

http://www.summitracing.com/parts/PRF-30141

shoot me an email at [email protected] and i will send you everything i have on electric fan installations.

 

[v8only]

on my 66 there wasn't nearly enough.room to.install that giant Taurus fan unless I cut it down....at that point it looked like.crap so I scrapped the idea
Sent from my SPH-D710 using Tapatalk 2

 

[Federico Garza]

on my 66 there wasn't nearly enough.room to.install that giant Taurus fan unless I cut it down....at that point it looked like.crap so I scrapped the idea
Sent from my SPH-D710 using Tapatalk 2

I already showed you how to fit it with just cutting 2 small slots on the rad. support, no need to butcher anything...

 

[v8only]

indeed i remember and will go that route....but many are unwilling to cut.up their car like that
Sent from my SPH-D710 using Tapatalk 2