Tired Of Leaving Washer Marks In Your Weld Wheels?

Rick 91GT

Mustang Master
Nov 29, 1999
9,692
95
99
PA
RNH Performance has your answer!

Over the years I always personally hated how the washers for the shank style lug nuts left marks in the aluminum wheels. Recently after a good friend powder coated his wheels I came up with a simple cost effective solution to prevent any new marks.

Designed, Tested and Guaranteed! Each kit comes with 25 UHMW pressure sensitive protectors, precison cut to fit the washers and a small assembly jig so there is no fumbling to align them up perfectly. (Each washer is slightly undersize so they can not be seen once installed). Custom sizes available at no extra cost!

$16 plus shipping, in stock ready to go.

Stop damaging your aftermarket wheels!

Rick
[email protected]
 
  • Sponsors (?)


So simple yet so effective. I tested them out on freshly powdered Weld ProStars. These protectors and whatever the heck they are made of ( im no scientist!) are awesome. Full torque on them and take it all. No scratches or powder chips!!!

Thanks RNH!