Mstng93SSP You have a nice rear end there Dave. 15 Year Member Nov 29, 1999 2,974 3,625 184 Mililani, Hawaii Jun 23, 2012 #1 Jun 23, 2012 #1 Can someone tell me what size and thread the screw is that holds the top cover on a tubular GT 40 intake? There are two screws in the upper part of the intake and two on the throttle body side. Thanks Chris
Can someone tell me what size and thread the screw is that holds the top cover on a tubular GT 40 intake? There are two screws in the upper part of the intake and two on the throttle body side. Thanks Chris
jrichker StangNet's favorite TOOL In Remembrance. Thank you for your contributions Mar 10, 2000 27,513 2,864 234 Dublin GA Jun 24, 2012 #2 Jun 24, 2012 #2 Screw size is 10-32, length is about 1/2"
4G-KDMP 10 Year Member Jul 23, 2005 934 16 39 CA Jun 24, 2012 #3 Jun 24, 2012 #3 10-32 x 1/2" ? I thought it was the same as the stock screws.... 8-32 x 1/2"
jrichker StangNet's favorite TOOL In Remembrance. Thank you for your contributions Mar 10, 2000 27,513 2,864 234 Dublin GA Jun 24, 2012 #4 Jun 24, 2012 #4 Buy both sizes, for less than $1.00 you can have all the bases covered...