92 Lx: No Turn Signals, Can't Find Relay/efm

[strra]

Hello!
When I purchased this car a few months ago, the turn signals worked but kind of "flickered"... recently, they completely went out... however the hazards work just fine.
I checked all the fuses, replaced the flasher relay on the fuse box (which, I believe I found out later is the hazard flasher?), and replaced the multi-function switch. Still nothing.
I was reading around and found out that the flashers use a separate relay that's supposed to be located behind the glove box, but for the life of me, I cannot find it.
I've attached pictures of what I can see behind the glove box.
Thanks in advance for any help. This is getting expensive!

 

[Noobz347]

Take a look at # 14. Behind the radio-ish.

 

[Shawneebear93]

The fuse box is on the driver's side under the dash right by the door (as you can see from the picture). Sometimes I pull the bracket it's attached to down when I get out of the car! There is a diagram on the case of the fuse box. Hope this helps!

 

[strra]

UPDATE

Well, I have good news and worse news.

the blue thing at the bottom of the first picture was what i was looking for. i had to remove the glove box to get to it and pull it off of a metal bracket.

however, the bad news is replacing it didn't fix it...

the relay is the same as the hazard relay, correct? they're interchangeable?

weird thing is, i tested the turn signal relay in the hazard relay slot and the hazards stopped working right until i replaced the original

i also popped out the hazard switch (i've read about loose wires) and checked all the connections and fiddled with the wires a bit, then did the same to the multifunction switch.

still absolutely nothing.

i'm quickly running out of ideas here. i don't want to have to bring the car in!



thank you guys for all your help.

 

[tca7291]

The hazard and the turn signal relay are identical. They are both your generic flasher units, round case and two prongs in a "L" shape. |_ If you interchanged them and are still having issues with your turn signals, you probably have some other wiring issue.