Hello, Im new to the forums. just bought a 1989 mustang LX hatch in pieces and have been slowly piecing it together over the last month. spending a lot of time in junkyards and autoparts stores but im nearing the light at the end of the tunnel I think. harness is almost completely installed, engines now in and bolted down.
engines in, new radiator, hoses and waterpump.
set of mac headers i picked up for $60 used because the car came missing the passenger side header and I couldnt find a wrecker that had one. already removed all the smog stuff off the motor. simplified the vacuum lines which on the harness most were cracked
to do/buy list:
install headers
starter
alternator
need to find a HEGO harness as the car was missing it
cone air filter
electric fan setup
coolent temp sensor
air sensor (the one under the plenum in the intake runner
ignition module
oil change
fill rad with coolent
set timing
engines in, new radiator, hoses and waterpump.
set of mac headers i picked up for $60 used because the car came missing the passenger side header and I couldnt find a wrecker that had one. already removed all the smog stuff off the motor. simplified the vacuum lines which on the harness most were cracked
to do/buy list:
install headers
starter
alternator
need to find a HEGO harness as the car was missing it
cone air filter
electric fan setup
coolent temp sensor
air sensor (the one under the plenum in the intake runner
ignition module
oil change
fill rad with coolent
set timing
