i know this is short notice, but im taking my 351w block to the local ford guy tomorrow morning to have him check it out and determine if its acceptable to use it for my build... im planning to stroke it to a 408. the block is from a 1982 truck, im not sure if it was a f-150 or f-250. Anyway, are there any questions or things i should bring up when i drop it off to him? i plan for him to clean and inspect the block, and if all looks good, then prep it for the 408. Paint, plugs, new bearings, bore, hone, and install the rotating assembly. Then ill take it home and finish the job anything you can think of that i should watch out for? thanks!