I read on another forum of someone using http://www.uprproducts.com/mustang-abs-plastic-boost-master-tube.html#customer-reviews on an N/A motor kinda like the one anderson has.. Has anyone else done this? And confirm that it will work?
Upr Boost Pipe On N/a?
- Thread starter robert fugate
- Start date
-
Sponsors (?)
I made my own out of intercooler tubing. Smoothed my idle and throttle response was dramatic to say the least
I wanna put the filter and maf in the fender to keep to cooler. But by the time i would build my own with the pipe and coupler. (Refuse to use PVC dont even bring it up) I could almost buy the anderson one. I guess I'll just go that route then.
I used some electrical conduit once that had a nice bend in it. As far as a "boost pipe" on an n/a how would that be any different than you're generic run of the mill cai? I call bogus on claims of gain. "Throttle response."
Negatron. I had mine fabbed abd installed for under 50 dollars. All aluminum and silicone elbows. Filter and maf are in the fender where they should have been from the factory.
I can't think of any car that has the filter in the fender from the factory. Kind of makes it hard to do filter changes.
Kurt
Kurt
Sharad
ALWAYS choose the V over the P!!! Wait... what?
I would certainly help to answer the question if I could, but I don't know of anyone running our Boostmaster pipe NA.
I happen to know for a fact that it is a real nice, clean piece for a supercharged car!
