Fuel Injector Wire Clip

[89llx]

The clip that holds the wire coulpler to my injector broke, how should I fix it?

or will it be ok like it is?


Thanks!!!!!!!!!!!!!!!!!!!!

 

[7991LXnSHO]

If it is just the clip arm of the plug, it will be fine until it decides to fall off in the middle of nowhere or you bump off the plug checking the oil.

I bought a set of pigtails off of eBay for not much. Solder and heat shrink your connections.

 

[Onefine88]

I have a couple of the clips broken on my injector connectors. They seem to hold together just fine but last time I was there I put a small "teeeeny" little drop of super glue on each connector just to be sure.

 

[89llx]

I was thinking about the super glue also

 

[mikestang63]

a small zip tie wrapped around the clip and the injector will work as well

 

[89llx]

Zip tie sounds good too

 

[Onefine88]

I was thinking about the super glue also

Remember all it'll take is a tiny little drop. I used thick super glue too, not the water thin. If it gets glued too well you'll probably have to destroy them later to get them apart.

Good Luck