Hello so I am about to replace my radiator and have run into trouble because of the transmission cooling lines. I don't want to break these lines but I have low hopes that I will because they are sooo rusted. I have hit them with that Buster spray and have gone out and bought a 1/2 flare wrench but thought I ask for some ideas. I ordered a new radiator and it came with a set of different connectors but I thought once I accidentally break then lines, these different connectors may come in handy to connect to hose in between the repair. I was even thinking of just cutting these at some point instead of breaking them. Is there a lot on pressure running through these? Also are they full of trans. fluid in there or does ti pump out when engine running? I am open and hoping for suggestions. Thanks