Installing performer manifold/ 500 cfm carb on my 66 c-code.At the last stages of project.I have the threaded/solid rod throttle with dog leg.and at the end it has a 90 degree.bend where it went into old 2100 carb.The threaded end is back by the fire wall.I screwed it all the way out but cam up 3/4 of an inch short of hole on new Edel.throttle arm.Everything lines up no interferences,just to short.Any ideas from those who have been here? Adapter etc.Had it fit would have drilled small hole at the end for cotter key and been done. Thanks to all ,as I tried to cut to the chase .