this is the last of the welding ,the quarter window holes are filled in .i cut a patch of 18 gauge, formed it to fit and held it in place with a welders magnet.great for hands free work. i tacked all the corners first then about every half inch making sure the surfaces were flush all the way around and fully welded them in.i ground the welds and it was done. it is ready for sand blasting and epoxy primer. i have to shuffle a few cars around to get it in the paint booth ,the 69 is temporarily getting evicted . once blasted i have to seal all the seams with 3M tan seam sealer then red oxide prime. going to check with my paint shop again to see if they have red oxide primer yet ,if not i will order SPI red oxide . one last look before blasting .