i got the floor and the small patch in the toe board done today.i butt welded the toe board in. i made my cut in the middle of the flange on the frame rail so the weld would not be seen in the engine compartment , the top weld will be hidden by the torque box. i used my hole punch on the edges of the floor pan,another one of those you need it tools.mine punches a 3/16 hole ,just perfect for plug welds. the floor went just perfect. nice and tight all the way around. i used a hand full of screws to pull it down tight then welded it down .even my welder worked good today. it made the prettiest welds ,nice and flat .just a light buff with my angle grinder and the welds were smooth.
i cut the quarters off the red 65 this morning ,what a mess. the outer wheel tubs have been patched by taking a new one and notching it out and slipping it over the old rotten ones, at least twice . the inners look like a quilt ,lots of patch work. the quarters were new but very poorly replaced. i am going to have a lot of clean up before i can get started on this one.
i took the door hinges apart ,sand blasted and primed them, put in new bushings and put them back together with new pins . one of the springs is headed to the moon i think ,it took off like a rocket .i heard it bounce off the walls a couple of times and then it was gone. good thing i had another one. i remembered today that i have a pass. side door. i have had it so long i forgot about it. i guess i will buy a Dynacorn driver door. i bolted the door on . it lines up pretty good .it was a new door that a friend gave me because it has a small dent in the middle of it ,easy to fix.
i started cutting my friends car apart. i took off most of the roof, just need to trim off the very front. took out part of the tail panel . i left the latch assembly ,it is good so i will just trim off the rest of the tail panel. i removed the back seat area and the back window strip. the car didn't even flex when the roof went through. it already has torque boxes so it is fairly solid. another friend has a set of doors for my 66 so i will pick them up tomorrow. i have to go to Harbor Freight tomorrow and get some more jack stands ,they are on sale right now and he lives just down the road from Harbor Freight.
i unloaded my friends car this morning ,it is a 65. the floor has been replaced and so has the trunk floors and rear quarters .i forgot i partially sand blasted it a few months back,it still hasn't been primed. i will start cutting this weekend.
it has a very nice roof ,any one need a 65 roof? if not i am going to cut it up. i don't have a place to store another roof. i will probably start cutting Sunday