Separate names with a comma.
Where did the car end up...still in Vegas?
Did this once. The pump made a hairline crack and would leak oil when hot. It took me a while to figure it out.
After trying to quickly and...
Sounds good man.:nice:
I dont mean to be THAT guy, but those welds looked really cold.
I really hope there was good weld pennetration.
Oh, and you can get a mig...
Where are you at?
If you are near CA, I will make you a smokin' deal on an entire carb setup.
Hard to believe the axle is bent and the housing is not.
If they end up totaling it out, liet me know. I am looking for a project.
Are they pedestal mount or stud mount rockers?
Do you have the correct length pushrods?
Do you have all the tools to do it?
I dont know many messicans that are named Dave...:shrug:
:scratch: Actually, I dont know any...
Did you get tubes for those things?
What pistons are they?
I am pretty sure they are either closed, or in the process of closing. They just had a few auctions and sold a whole lot of equipment, goods,...
Thats rough mang...
Maybe the belt just let go?
Modular...How you been?
Got any recent pics of your engine...?
Regardless of your ring choice, a proper hone is imperative for the proper ring seal.
Even a cheap monkey ball honer will be better than...
Same here...I bought one from BBK for shorties, and had to have it cut and welded.
Even my Bassani one I had to cut up and re...
OP, where are you located?
And What mods are done to the car?
Can you PM me the details on this? I need to get my car registered...:nice:
If it is a fox mid pipe, the hangers would interfere with the trans crossmember. Look to see if there are cut/grind marks near where the tubes...
Too much cost for any real bennefit. A quality sey of bolts or studs is all you need.
The arp-154-4005 Includes 1/2 in. to 7/16 in. insert washers for cylinder heads with 1/2 in. bolt holes.