Separate names with a comma.
how can I purchase email me [email protected]
The use of the 10k ohm resistors did not work. I also would say this has to be a bad gauge but trying to fight the idea that that is true.
back from the DEAD............
trying to resolve this same issue. I was told by autometer to put a inline resistor 10k from radio shack ?
got ET times from just the basic kit
I have 91 coupe AOD with 130K miles
I am putting a Trickflow kit together. I have trackheat intake, Tw heads,30lbers, 70mm Tb, 75mm mass,
where can spacer .330 be purchased online?
i think i used just flat washers 5/8 hole dia from Lowes?
solves everything then.
spindle spacer then castle nut.
When you install 94-95 spindles on Fox. The spacer (washer)goes before the spindle correct. I have done this before on a...
email from PA.
From what you describe, it sounds like the pump gears were broken during installation. That is caused by the torque...
The T5 parts are already sold. thanks
Well I called PA and they told me to check to see if the tranny is pumping fuild. I unhooked the...
it will not roll in park but will roll in every other gear>?
I am working on swapping out a 5spd 89 mustang GT. Installing a Pa Comp c4.
Tranny is install all is well car runs thr gears...
help this man...... me too....lol
CCW cal car cover is what I use ...........water beeds off of it like a nice wax job.....haha.........car stays clean now.
what is the torque you should put the bolts back at of course evening?
I had a popping noise on my car checked rockers and found 2 bent pushrods. and 2 worn HYD Flattap Lifters .equaled to a worn lobe...
If you convert what is proper distributer gear? supposed to be steel bronze. etc ????
Pushrods Part# RP 3209.
Does anyone know the length of these. out of 351w
I have 351w seems to be flat tap
Cam is worn and I am replacing
what is this cam any ideas.
All the numbers that...